ISO 228-1:2000 Pipe threads where pressure-tight joints are not made on the threads - Part 1: Dimensions, tolerances and designation

Abbreviation
ISO 228-1:2000
Valid from
21/09/2000
Replaces
ISO 228-1:1994,

Information provider
Standards New Zealand,
Author
International Organization for Standardization
Information type
ISO Standard,
Format
PDF, HARD COPY,


Description

This part of ISO 228 specifies the requirements for thread form, dimensions, tolerances and designation for fastening pipe threads, thread sizes 1/16 to 6 inclusive. Both internal and external threads are parallel threads, intended for the mechanical assembly of the component parts of fittings, cocks and valves, accessories, etc.

These threads are not suitable as jointing threads where a pressure-tight joint is made on the thread. If assemblies with such threads must be made pressure-tight, this should be effected by compressing two tightening surfaces outside the threads, and by interposing an appropriate seal.

Note 1) For pipe threads where pressure-tight joints are made on the threads, see ISO 7-1.

Note 2) ISO 228-2 gives details of methods for verification of fastening thread dimensions and form, and recommended gauging systems.

For assistance with locating previous versions, please contact the information provider.
View on Information Provider website
For assistance with locating previous versions, please contact the information provider.
This resource is cited by:

ISO 228-1:2000 Pipe threads where pressure-tight joints are not made on the threads - Part 1: Dimensions, tolerances and designation

This document is CITED BY:

ISO 228-1:2000 Pipe threads where pressure-tight joints are not made on the threads - Part 1: Dimensions, tolerances and designation

Description

This part of ISO 228 specifies the requirements for thread form, dimensions, tolerances and designation for fastening pipe threads, thread sizes 1/16 to 6 inclusive. Both internal and external threads are parallel threads, intended for the mechanical assembly of the component parts of fittings, cocks and valves, accessories, etc.

These threads are not suitable as jointing threads where a pressure-tight joint is made on the thread. If assemblies with such threads must be made pressure-tight, this should be effected by compressing two tightening surfaces outside the threads, and by interposing an appropriate seal.

Note 1) For pipe threads where pressure-tight joints are made on the threads, see ISO 7-1.

Note 2) ISO 228-2 gives details of methods for verification of fastening thread dimensions and form, and recommended gauging systems.

View on Information Provider website
ISO 228-1:2000 Pipe threads where pressure-tight joints are not made on the threads - Part 1: Dimensions, tolerances and designation
Description

This part of ISO 228 specifies the requirements for thread form, dimensions, tolerances and designation for fastening pipe threads, thread sizes 1/16 to 6 inclusive. Both internal and external threads are parallel threads, intended for the mechanical assembly of the component parts of fittings, cocks and valves, accessories, etc.

These threads are not suitable as jointing threads where a pressure-tight joint is made on the thread. If assemblies with such threads must be made pressure-tight, this should be effected by compressing two tightening surfaces outside the threads, and by interposing an appropriate seal.

Note 1) For pipe threads where pressure-tight joints are made on the threads, see ISO 7-1.

Note 2) ISO 228-2 gives details of methods for verification of fastening thread dimensions and form, and recommended gauging systems.

View on Information Provider website
This resource does not cite any other resources.

ISO 228-1:2000 Pipe threads where pressure-tight joints are not made on the threads - Part 1: Dimensions, tolerances and designation

This resource does not CITE any other resources.
Feedback