ISO 228-1:1994 Pipe threads where pressure-tight joints are not made on the threads - Part 1: Dimensions, tolerances and designation

Abbreviation
ISO 228-1:1994
Valid from
12/05/1994

Information provider
Standards New Zealand,
Author
International Organization for Standardization
Information type
ISO Standard,
Format
PDF, HARD COPY,


Description

This standard specifies the requirements for thread form, dimensions, tolerances, and designation for fastening pipe threads. Both internal and external threads are parallel threads.

For assistance with locating previous versions, please contact the information provider.
View on Information Provider website
For assistance with locating previous versions, please contact the information provider.
This resource is cited by:

ISO 228-1:1994 Pipe threads where pressure-tight joints are not made on the threads - Part 1: Dimensions, tolerances and designation

This document is CITED BY:

ISO 228-1:1994 Pipe threads where pressure-tight joints are not made on the threads - Part 1: Dimensions, tolerances and designation

Description

This standard specifies the requirements for thread form, dimensions, tolerances, and designation for fastening pipe threads. Both internal and external threads are parallel threads.

View on Information Provider website
ISO 228-1:1994 Pipe threads where pressure-tight joints are not made on the threads - Part 1: Dimensions, tolerances and designation
Description

This standard specifies the requirements for thread form, dimensions, tolerances, and designation for fastening pipe threads. Both internal and external threads are parallel threads.

View on Information Provider website
This resource does not cite any other resources.

ISO 228-1:1994 Pipe threads where pressure-tight joints are not made on the threads - Part 1: Dimensions, tolerances and designation

This resource does not CITE any other resources.
Feedback