AS ISO 7.1-2008 (R2017) Pipe threads where pressure-tight joints are made on the threads - Dimensions, tolerances and designation

Abbreviation
AS ISO 7.1-2008
Valid from
13/02/2008

Information provider
Intertek Inform,
Author
Standards Australia
Information type
Australian Standard,
Format
PDF, HARD COPY,


Description

This Standard adopts ISO 7-1:1994 to specify requirements for thread form, dimensions, tolerances and designation for jointing pipe threads, sizes 1/16 to 6 inclusive, for joints made pressure-tight by the mating of the threads.

Scope

The objective of this Standard is to provide manufacturers of pipe fittings and associated equipment with the dimensions and tolerances for pipe threads where pressure-tight joints are made on the threads.

This Standard is Part 1 of a two-part series on pipe threads where pressure-tight joints are made on the threads. Part 2 specifies a method by which the threads can be verified by means of limit gauges.

This Standard is identical with and has been reproduced from ISO 7-1:1994, Pipe threads where pressure-tight joints are made on the threads, Part 1: Dimensions, tolerances and designation and Technical Corrigendum 1 to ISO-7:1994. Technical Corrigendum 1 (2007), which corrects Figure 5, is inserted at the end of the text.

For assistance with locating previous versions, please contact the information provider.
Notes/comments

Standard was reconfirmed 16 June 2017

View on Information Provider website
For assistance with locating previous versions, please contact the information provider.

Standard was reconfirmed 16 June 2017

This resource is cited by:

AS ISO 7.1-2008 (R2017) Pipe threads where pressure-tight joints are made on the threads - Dimensions, tolerances and designation

This document is CITED BY:

AS ISO 7.1-2008 (R2017) Pipe threads where pressure-tight joints are made on the threads - Dimensions, tolerances and designation

Description

This Standard adopts ISO 7-1:1994 to specify requirements for thread form, dimensions, tolerances and designation for jointing pipe threads, sizes 1/16 to 6 inclusive, for joints made pressure-tight by the mating of the threads.

View on Information Provider website
AS ISO 7.1-2008 (R2017) Pipe threads where pressure-tight joints are made on the threads - Dimensions, tolerances and designation
Description

This Standard adopts ISO 7-1:1994 to specify requirements for thread form, dimensions, tolerances and designation for jointing pipe threads, sizes 1/16 to 6 inclusive, for joints made pressure-tight by the mating of the threads.

View on Information Provider website
This resource does not cite any other resources.

AS ISO 7.1-2008 (R2017) Pipe threads where pressure-tight joints are made on the threads - Dimensions, tolerances and designation

This resource does not CITE any other resources.
Feedback