BS EN 14399-2:2015 High-strength structural bolting assemblies for preloading. Suitability for preloading

Abbreviation
BS EN 14399-2:2015
Valid from
1/01/2015

Information provider
Standards New Zealand,
Author
British Standards Institution, European Standardization Organisations
Information type
European Standard,
Format
PDF, HARD COPY,


Description

This European Standard specifies a tightening test to verify the suitability of high strength bolt/nut/washer assemblies for preloaded bolted connection in metallic structures.

The purpose of this test is to check the behaviour of the fastener assembly so as to ensure that the required preload can be reliably obtained by the tightening methods specified in ENV 1090-1 with sufficient margins against over tightening and against failure.

For assistance with locating previous versions, please contact the information provider.
View on Information Provider website
For assistance with locating previous versions, please contact the information provider.
This resource is cited by:

BS EN 14399-2:2015 High-strength structural bolting assemblies for preloading. Suitability for preloading

This document is CITED BY:

BS EN 14399-2:2015 High-strength structural bolting assemblies for preloading. Suitability for preloading

Description

This European Standard specifies a tightening test to verify the suitability of high strength bolt/nut/washer assemblies for preloaded bolted connection in metallic structures.

The purpose of this test is to check the behaviour of the fastener assembly so as to ensure that the required preload can be reliably obtained by the tightening methods specified in ENV 1090-1 with sufficient margins against over tightening and against failure.

View on Information Provider website
BS EN 14399-2:2015 High-strength structural bolting assemblies for preloading. Suitability for preloading
Description

This European Standard specifies a tightening test to verify the suitability of high strength bolt/nut/washer assemblies for preloaded bolted connection in metallic structures.

The purpose of this test is to check the behaviour of the fastener assembly so as to ensure that the required preload can be reliably obtained by the tightening methods specified in ENV 1090-1 with sufficient margins against over tightening and against failure.

View on Information Provider website
This resource cites:

BS EN 14399-2:2015 High-strength structural bolting assemblies for preloading. Suitability for preloading

This document CITES:
Feedback