BS EN 10025-2:2004 Hot rolled products of structural steels. Part 2: Technical delivery conditions for non-alloy structural steels
- Abbreviation
- BS EN 10025-2:2004
- Valid from
- 17/11/2004
- Information provider
- Standards New Zealand,
- Author
- British Standards Institution, European Standardization Organisations
- Information type
- European Standard,
- Format
- PDF, HARD COPY,
Description
This European Standard, a part of the BS EN 10025 series, specifies the technical delivery conditions for flat and long products and semi-finished products which are meant for further processing to flat and long products of hot rolled non-alloy quality steels in the grades and qualities given in chemical composition tables and mechanical properties tables in the delivery conditions. Chemical composition and mechanical properties of three engineering steels are also specified. This standard does not apply to structural hollow sections and tubes.
BS EN 10025-2:2004 is the same as EN 10025-2:2004
Scope
Part 2 of this document, in addition to Part 1, specifies the technical delivery conditions for flat and long products and semi-finished products which are meant for further processing to flat and long products of hot rolled non-alloy quality steels in the grades and qualities given in Tables 2 to 6 (chemical composition) and Tables 7 to 9 (mechanical properties) in the delivery conditions as given in 6.3. Three engineering steels are also specified in this document (see Tables 3 and 5) (chemical composition) and Table 8 (mechanical properties). This document does not apply to structural hollow sections and tubes (see EN 10210-1 and EN 10219-1).
The technical delivery conditions apply to thicknesses ≥ 3 mm and ≤ 150 mm for long products of steel grade S450J0. The technical delivery conditions apply to thicknesses ≤ 250 mm for flat and long products of all other grades and qualities. In addition for flat products of qualities J2 and K2 the technical conditions apply to thicknesses ≤ 400 mm.
Products made of steel grades S185, E295, E335 and E360 cannot be CE marked.
The steels specified in this Part 2 are not intended to be heat treated except products delivered in delivery condition +N. Stress relief annealing is permitted (see also the Note in 7.3.1.1 of EN 10025-1:2004). Products delivered in +N condition can be hot formed and/or normalized after delivery (see Clause 3).
This resource is cited by:
BS EN 10025-2:2004 Hot rolled products of structural steels. Part 2: Technical delivery conditions for non-alloy structural steels
This document is CITED BY:
-
BS 10:2009
BS EN 10025-2:2004 is cited by BS 10:2009 Specification for flanges and bolting for pipes, valves and fittings
-
BS EN 115-1:2008
BS EN 10025-2:2004 is cited by BS EN 115-1:2008 Safety of escalators and moving walks Part 1: Construction and installation
-
BS EN 12285-2:2005
BS EN 10025-2:2004 is cited by BS EN 12285-2:2005 Workshop fabricated steel tanks - Horizontal cylindrical single skin and double skin tanks for the aboveground storage of flammable and non-flammable water polluting liquids
-
BS EN 81-50:2014
BS EN 10025-2:2004 is cited by BS EN 81-50:2014 Safety rules for the construction and installation of lifts. Examinations and tests. Design rules, calculations, examination and tests of lift components
-
NZS 3404 Parts 1 and 2:1997
BS EN 10025-2:2004 is cited by NZS 3404 Parts 1 and 2:1997 Steel structures standard - SPONSORED