AS/NZS 4534:1998 Zinc and zinc/aluminium-alloy coatings on steel wire

Abbreviation
AS/NZS 4534:1998
Amendment
A1 - This amendment must be purchased separately. Published 26/04/2001.
Valid from
4/01/1998

Information provider
Standards New Zealand
Author
Standards New Zealand, Standards Australia
Information type
New Zealand Standard
Format
PDF


Description

This Standard specifies requirements for mass, quality and testing of zinc coatings and zinc/aluminium-alloy coatings on steel wire of circular or non-circular cross-section.

The coatings are applied using a continuous process which may comprise immersion in molten metal or electrodeposition.

The Standard applies to coatings on wire at its final size and specifies six coating mass classes. It specifies methods for the determination of coating mass and gives advice on the transport and storage of coated wires, and on coating selection for corrosion protection.

Scope

Six coating mass classes are covered. 

Matters not relating to the coating itself are outside the scope of this Standard.

This Standard does not apply to coatings on articles that have been fabricated from uncoated steel wire and which have subsequently been coated with zinc or zinc/aluminium alloy, except where the coating has been applied in a specialized continuous process (e.g. for wire netting) as opposed to batch treatment (e.g. for nails).

For assistance with locating previous versions, please contact the information provider.
View on Information Provider website
For assistance with locating previous versions, please contact the information provider.
This resource is cited by:

AS/NZS 4534:1998 Zinc and zinc/aluminium-alloy coatings on steel wire

This document is CITED BY:

AS/NZS 4534:1998 Zinc and zinc/aluminium-alloy coatings on steel wire

Description

This Standard specifies requirements for mass, quality and testing of zinc coatings and zinc/aluminium-alloy coatings on steel wire of circular or non-circular cross-section.

The coatings are applied using a continuous process which may comprise immersion in molten metal or electrodeposition.

The Standard applies to coatings on wire at its final size and specifies six coating mass classes. It specifies methods for the determination of coating mass and gives advice on the transport and storage of coated wires, and on coating selection for corrosion protection.

View on Information Provider website
AS/NZS 4534:1998 Zinc and zinc/aluminium-alloy coatings on steel wire
Description

This Standard specifies requirements for mass, quality and testing of zinc coatings and zinc/aluminium-alloy coatings on steel wire of circular or non-circular cross-section.

The coatings are applied using a continuous process which may comprise immersion in molten metal or electrodeposition.

The Standard applies to coatings on wire at its final size and specifies six coating mass classes. It specifies methods for the determination of coating mass and gives advice on the transport and storage of coated wires, and on coating selection for corrosion protection.

View on Information Provider website
This resource does not cite any other resources.

AS/NZS 4534:1998 Zinc and zinc/aluminium-alloy coatings on steel wire

This resource does not CITE any other resources.
Feedback