ISO 75-3:2004 (R2017) Plastics - Determination of temperature of deflection under load - Part 3: High-strength thermosetting laminates and long-fibre-reinforced plastics

Abbreviation
ISO 75-3:2004
Valid from
12/05/2004

Information provider
Standards New Zealand,
Author
International Organization for Standardization
Information type
ISO Standard,
Format
PDF, HARD COPY,


Description

This part of ISO 75 specifies a method for the determination of the temperature of deflection under a load of high-strength thermosetting laminates and compression-moulded long-fiber-reinforced plastics in which the fiber length is greater than 7,5 mm.

The flexural stress used is not fixed, as in ISO 75-2, but is a fraction (1/1000) of the initial (room-temperature) flexural modulus of the material under test. This allows the method to be applied to materials with a wide range of flexural moduli.

For additional information, see ISO 75-1:2004, clause 1.

For assistance with locating previous versions, please contact the information provider.
Notes/comments

This Standard is referenced by AS/NZS 1546.1:2008 in regard to septic tanks.

View on Information Provider website
For assistance with locating previous versions, please contact the information provider.

This Standard is referenced by AS/NZS 1546.1:2008 in regard to septic tanks.

This resource is cited by:

ISO 75-3:2004 (R2017) Plastics - Determination of temperature of deflection under load - Part 3: High-strength thermosetting laminates and long-fibre-reinforced plastics

This document is CITED BY:

ISO 75-3:2004 (R2017) Plastics - Determination of temperature of deflection under load - Part 3: High-strength thermosetting laminates and long-fibre-reinforced plastics

Description

This part of ISO 75 specifies a method for the determination of the temperature of deflection under a load of high-strength thermosetting laminates and compression-moulded long-fiber-reinforced plastics in which the fiber length is greater than 7,5 mm.

The flexural stress used is not fixed, as in ISO 75-2, but is a fraction (1/1000) of the initial (room-temperature) flexural modulus of the material under test. This allows the method to be applied to materials with a wide range of flexural moduli.

For additional information, see ISO 75-1:2004, clause 1.

View on Information Provider website
ISO 75-3:2004 (R2017) Plastics - Determination of temperature of deflection under load - Part 3: High-strength thermosetting laminates and long-fibre-reinforced plastics
Description

This part of ISO 75 specifies a method for the determination of the temperature of deflection under a load of high-strength thermosetting laminates and compression-moulded long-fiber-reinforced plastics in which the fiber length is greater than 7,5 mm.

The flexural stress used is not fixed, as in ISO 75-2, but is a fraction (1/1000) of the initial (room-temperature) flexural modulus of the material under test. This allows the method to be applied to materials with a wide range of flexural moduli.

For additional information, see ISO 75-1:2004, clause 1.

View on Information Provider website
This resource does not cite any other resources.

ISO 75-3:2004 (R2017) Plastics - Determination of temperature of deflection under load - Part 3: High-strength thermosetting laminates and long-fibre-reinforced plastics

This resource does not CITE any other resources.
Feedback