Skip to main content Skip to primary navigation
Resource detail
Citations

ISO 3459:2015 Plastic piping systems — Mechanical joints between fittings and pressure pipes — Test method for leaktightness under negative pressure.

View on Information Provider website
Abbreviation
ISO 3459:2015
Valid from
26/02/2015
Information provider
Standards New Zealand,
Author
International Organization for Standardization
Information type
ISO Standard,
Format
PDF, HARD COPY,
Cited By
This resource is cited by 2 documents (show Citations)
Description

ISO 3459:2015 specifies two methods of testing for checking the leaktightness of assembled joints between mechanical fittings and plastic pressure pipes up to and including 63 mm. The test applies regardless of the design and material of the fitting used for jointing plastics pipe.

This test method is not applicable to fusion-welded joints.

For assistance with locating previous versions, please contact the information provider.
View on Information Provider website
For assistance with locating previous versions, please contact the information provider.
This resource is cited by:

ISO 3459:2015 Plastic piping systems — Mechanical joints between fittings and pressure pipes — Test method for leaktightness under negative pressure.

This document is CITED BY:

ISO 3459:2015 Plastic piping systems — Mechanical joints between fittings and pressure pipes — Test method for leaktightness under negative pressure.

Description

ISO 3459:2015 specifies two methods of testing for checking the leaktightness of assembled joints between mechanical fittings and plastic pressure pipes up to and including 63 mm. The test applies regardless of the design and material of the fitting used for jointing plastics pipe.

This test method is not applicable to fusion-welded joints.

View on Information Provider website
ISO 3459:2015 Plastic piping systems — Mechanical joints between fittings and pressure pipes — Test method for leaktightness under negative pressure.
Description

ISO 3459:2015 specifies two methods of testing for checking the leaktightness of assembled joints between mechanical fittings and plastic pressure pipes up to and including 63 mm. The test applies regardless of the design and material of the fitting used for jointing plastics pipe.

This test method is not applicable to fusion-welded joints.

View on Information Provider website
This resource does not cite any other resources.

ISO 3459:2015 Plastic piping systems — Mechanical joints between fittings and pressure pipes — Test method for leaktightness under negative pressure.

This resource does not CITE any other resources.
Feedback