ISO 2566-1:1984 Carbon and low alloy steels

Abbreviation
ISO 2566-1:1984
Valid from
1/07/1984

Information provider
Standards New Zealand,
Author
ISO
Information type
ISO Standard,
Format
PDF, HARD COPY,


Description

This part of ISO 2566 specifies a method of converting room temperature percentage elongations after fracture obtained on various proportional and non-proportional gauge lengths to other gauge lengths.

The formula on which conversions are based is considered to be reliable when applied to carbon, carbon manganese, molybdenum and chromium molybdenum steels within the tensile strength range 300 to 700 N/mm2 and in the hot-rolled, hot-rolled and normalized or annealed conditions, with or without tempering.

Scope

These conversions are not applicable to:

  • cold reduced steels;
  • quenched and tempered steels;
  • austenitic steels.

Neither should they be used where the gauge length exceeds mml_m3 or where the width to thickness ratio of the test piece exceeds 20. Care should be exercised in the case of strip under 4 mm thickness, as the index in the formula given in clause 4 in-creases with decreasing thickness; the value to be used shall be the subject of agreement between the customer and the supplier.

For assistance with locating previous versions, please contact the information provider.
View on Information Provider website
For assistance with locating previous versions, please contact the information provider.
This resource is cited by:

ISO 2566-1:1984 Carbon and low alloy steels

This document is CITED BY:

ISO 2566-1:1984 Carbon and low alloy steels

Description

This part of ISO 2566 specifies a method of converting room temperature percentage elongations after fracture obtained on various proportional and non-proportional gauge lengths to other gauge lengths.

The formula on which conversions are based is considered to be reliable when applied to carbon, carbon manganese, molybdenum and chromium molybdenum steels within the tensile strength range 300 to 700 N/mm2 and in the hot-rolled, hot-rolled and normalized or annealed conditions, with or without tempering.

View on Information Provider website
ISO 2566-1:1984 Carbon and low alloy steels
Description

This part of ISO 2566 specifies a method of converting room temperature percentage elongations after fracture obtained on various proportional and non-proportional gauge lengths to other gauge lengths.

The formula on which conversions are based is considered to be reliable when applied to carbon, carbon manganese, molybdenum and chromium molybdenum steels within the tensile strength range 300 to 700 N/mm2 and in the hot-rolled, hot-rolled and normalized or annealed conditions, with or without tempering.

View on Information Provider website
This resource does not cite any other resources.

ISO 2566-1:1984 Carbon and low alloy steels

This resource does not CITE any other resources.
Feedback