BS EN 1112:2008 Sanitary tapware. Shower outlets for sanitary tapware for water supply systems type 1 and type 2. General technical specification
- Abbreviation
- BS EN 1112:2008
- Valid from
- 29/08/2008
- Information provider
- British Standards Institution,
- Author
- British Standards Institution, European Standardization Organizations
- Information type
- British Standard,
- Format
- PDF, HARD COPY,
Description
This Standard specifies:
the dimensional, leaktightness, mechanical, hydraulic and acoustic characteristics with which shower outlets shall comply;
the procedures for testing these characteristics.
This Standard applies to shower heads and hand showers of any material used for ablutionary purposes and intended for equipping and supplementing sanitary tapware for baths and showers.
Scope
This Standard applies to shower heads and hand showers connected downstream of the obturator of the tapware.
Integral and remote spray attachments incorporated in tapware (e.g. sink and wash basin mixing valves) are
not covered by this standard.
This resource is cited by:
BS EN 1112:2008 Sanitary tapware. Shower outlets for sanitary tapware for water supply systems type 1 and type 2. General technical specification
This document is CITED BY:
-
BS EN 1111:2017
BS EN 1112:2008 is cited by BS EN 1111:2017 Sanitary tapware. Thermostatic mixing valves (PN 10). General technical specification
-
BS EN 1287:2017
BS EN 1112:2008 is cited by BS EN 1287:2017 Sanitary tapware. Low pressure thermostatic mixing valves. General technical specification