AS/NZS 4645.3:2008 Gas distribution networks - Part 3: Plastics pipe systems
- Abbreviation
- AS/NZS 4645.3:2008
- Amendment
- AS/NZS 4645.3:2008 A1 - incorporated, published 21/07/2010.
- Valid from
- 30/12/2008
- Information provider
- Standards New Zealand,
- Author
- Standards New Zealand, Standards Australia
- Information type
- New Zealand Standard,
- Format
- PDF, HARD COPY,
Description
This Standard provides more detailed requirements for design, materials, construction, testing and commissioning of plastic mains and services within a network and is to be used together with Part 1. It covers gas distribution networks covered by Part 1 of this Standard for operating pressures up to 600 kPa.
Scope
This Standard specifies materials, design, construction, installation, testing and maintenance requirements for below ground plastics gas distribution networks and shall be used in conjunction with AS/NZS 4645.1, for the distribution of fuel gas suitable for domestic, commercial or industrial uses, where;
- (a) plastics gas distribution networks include those constructed from materials including polyamide (PA), polyethylene (PE) and polyvinyl chloride (PVC-HI); and
- (b) the MAOP of the gas distribution network is not greater than 700 kPa except for plastics mains and services with a DN greater than 200 mm where the MAOP is limited to 600 kPa.
This resource is cited by:
AS/NZS 4645.3:2008 Gas distribution networks - Part 3: Plastics pipe systems
This document is CITED BY:
-
AS/NZS 5601.1:2010
AS/NZS 4645.3:2008 is cited by AS/NZS 5601.1:2010 Gas installations - Part 1: General installations
-
AS/NZS 5601.1:2013
AS/NZS 4645.3:2008 is cited by AS/NZS 5601.1:2013 Gas installations - General installations