AS/NZS 3661.1:1993 Slip resistance of pedestrian surfaces - Requirements
- Abbreviation
- AS/NZS 3661.1:1993
- Valid from
- 11/10/1993
- Information provider
- Standards New Zealand,
- Author
- Standards New Zealand, Standards Australia
- Information type
- New Zealand Standard,
- Format
- PDF, HARD COPY,
Description
This part of the AS/NZS 3661 specifies requirements and test methods for the measurement of the slip resistance of both wet and dry pedestrian surfaces.
Scope
This Standard specifies the minimum coefficient of friction values for pedestrian surfaces when measured in accordance with the test methods set out in Appendices A and B. These test methods enable characteristics of surface materials to be determined in either a wet or dry condition, and are appropriate for measurements to be undertaken either in the laboratory under conditions in which the surface materials are intended to be installed, or in situ after installation. Other test methods can be used to meet the compliance requirements specified herein, for example test procedures based on force plates. This Standard does not cover grating, and may not cover some resilient surfaces.
This resource is cited by:
AS/NZS 3661.1:1993 Slip resistance of pedestrian surfaces - Requirements
This document is CITED BY:
-
D1/AS1 (Amd 5) (Second Edition, Amendment 5)
AS/NZS 3661.1:1993 is cited by Acceptable Solution D1/AS1: Access Routes from 19/08/1994
-
D1/VM1 (Second edition, amendment 5)
AS/NZS 3661.1:1993 is cited by Verification Method D1/VM1 (Amd 5): Access Routes from 1/12/1993 until 31/05/2017
-
AS/NZS 4455:1997
AS/NZS 3661.1:1993 is cited by AS/NZS 4455:1997 Masonry units and segmental pavers