AS/NZS 2754.1(Int):2008 Adhesives for timber and timber products - Part 1: Adhesives for manufacture of plywood and laminated veneer lumber (LVL)

Abbreviation
AS/NZS 2754.1(Int):2008
Valid from
30/12/2008

Information provider
Standards New Zealand,
Author
Standards New Zealand, Standards Australia
Information type
New Zealand Standard,
Format
PDF, HARD COPY,


Description

This Standard provides the specifications for adhesives suitable for use in the plywood and laminated veneer lumber (LVL) manufacturing industry. This draft is prepared as an Interim standard awaiting the outcome of a major research project on new generation adhesives durability currently in progress.

Scope

This Interim Standard specifies requirements for adhesives suitable for use in the plywood and laminated veneer lumber (LVL) manufacturing industry, the criterion for suitability being the ability of an adhesive to produce bonded plywood and LVL products of defined types quality and durability under a range of exposure conditions and structural and non-structural conditions.

Table 1 provides details of the relationship between the standardized bond types A, B, C and D, the adhesive chemical type required for the bond type and the service conditions applicable to the four bond types. Pre-treatment requirements for each bond type are also specified in Table 1.

The Interim Standard does not specify the bond test methods which are detailed in AS/NZS 2098.2.

Test requirements for pH, non-volatile solids content, viscosity, gelation time and bond quality are also specified in the Interim Standard.

For assistance with locating previous versions, please contact the information provider.
Notes/comments

Note: AS/NZS 2754.1(Int):2008 when released was as an interim (Int) Standard, as such some Standards issued in the same year (2008) prior to the announcing of it's 'Interim' status refer to it as AS/NZS 2754.1:2008.

View on Information Provider website
For assistance with locating previous versions, please contact the information provider.

Note: AS/NZS 2754.1(Int):2008 when released was as an interim (Int) Standard, as such some Standards issued in the same year (2008) prior to the announcing of it's 'Interim' status refer to it as AS/NZS 2754.1:2008.

This resource is cited by:

AS/NZS 2754.1(Int):2008 Adhesives for timber and timber products - Part 1: Adhesives for manufacture of plywood and laminated veneer lumber (LVL)

This document is CITED BY:

AS/NZS 2754.1(Int):2008 Adhesives for timber and timber products - Part 1: Adhesives for manufacture of plywood and laminated veneer lumber (LVL)

Description

This Standard provides the specifications for adhesives suitable for use in the plywood and laminated veneer lumber (LVL) manufacturing industry. This draft is prepared as an Interim standard awaiting the outcome of a major research project on new generation adhesives durability currently in progress.

View on Information Provider website
AS/NZS 2754.1(Int):2008 Adhesives for timber and timber products - Part 1: Adhesives for manufacture of plywood and laminated veneer lumber (LVL)
Description

This Standard provides the specifications for adhesives suitable for use in the plywood and laminated veneer lumber (LVL) manufacturing industry. This draft is prepared as an Interim standard awaiting the outcome of a major research project on new generation adhesives durability currently in progress.

View on Information Provider website
This resource does not cite any other resources.

AS/NZS 2754.1(Int):2008 Adhesives for timber and timber products - Part 1: Adhesives for manufacture of plywood and laminated veneer lumber (LVL)

This resource does not CITE any other resources.
Feedback