AS 1418.12-1991 (R2016) Cranes (including hoists and winches) - Part 12: Crane collector systems
- Abbreviation
- AS 1418.12-1991 (R2016)
- Valid from
- 28/03/1991
- Information provider
- Intertek Inform,
- Author
- Standards Australia
- Information type
- Australian Standard,
- Format
- PDF, HARD COPY,
Description
This Standard specifies requirements for crane collector systems incorporating a sliding or rolling contact device. Does not cover direct-connected systems such as cable reelers or flexible cable systems.
Scope
This Standard specifies requirements for crane collector systems incorporating a sliding or rolling contact device, referred to herein as 'CCS', intended for use on;
- (a) alternating current systems, the rated voltage of which is greater than 32 V and does not exceed 1000 V, at frequencies from 25 Hz to 60 Hz; and
- (b) direct current systems, the rated voltage of which is greater than 115 V and does not exceed 1500 V. The Standard does not cover direct-connected systems such as slip rings, cable reelers or flexible cable systems.
Notes:
- Guidance on the installation checks of CCS is provided in Appendix A.
- Appendix B shows the typical components of a CCS, and cross-sections of enclosed CCS.
This resource is cited by:
AS 1418.12-1991 (R2016) Cranes (including hoists and winches) - Part 12: Crane collector systems
This document is CITED BY:
-
AS/NZS 1170.1:2002
AS 1418.12-1991 (R2016) is cited by AS/NZS 1170.1:2002 (R2016) Structural Design Actions - Permanent, imposed and other actions
-
NZS 3101.2:2006 (inc A1, A2, A3)
AS 1418.12-1991 (R2016) is cited by NZS 3101.2:2006 (inc A1, A2, A3) Concrete structures standard. - Part 2: Commentary on the design of concrete structures. - SPONSORED.
-
NZS 3404 Parts 1 and 2:1997
AS 1418.12-1991 (R2016) is cited by NZS 3404 Parts 1 and 2:1997 Steel structures standard - SPONSORED