AS 1397-1993 Steel sheet and strip - Hot-dipped zinc-coated or aluminium/zinc-coated

Abbreviation
AS 1397-1993
Valid from
14/06/1993

Information provider
Intertek Inform,
Author
Standards Australia
Information type
Australian Standard,
Format
PDF, HARD COPY,


Description

This Standard specifies requirements for formable and structural grades of hot-dipped zinc-coated and aluminium/zinc-coated sheet and strip, up to and including 5.0 mm thick. Gives information on coating thickness determination, fabricating characteristics and guidelines on the selection of specific grades.

Scope

This Standard specifies requirements for steel grades, coating classes and surface finish, as follows:

  • (a) Three formability grades of steel.
  • (b) Six structural grades of steel.
  • (c) Six classes of zinc coating.
  • (d) Two classes of zinc coating converted to zinc/iron alloy.
  • (e) Two classes of aluminium/zinc alloy coating.
  • (f) Surface finish.

Notes:

  1. Advice and recommendations on information to be supplied by the purchaser at the time of enquiry or order are contained in Appendix A.
  2. Alternative means for determining compliance with this Standard are given in Appendix B.
  3. The specified requirements apply to the full length and full width of the product supplied, unless otherwise indicated.
For assistance with locating previous versions, please contact the information provider.
View on Information Provider website
For assistance with locating previous versions, please contact the information provider.
This resource is cited by:

AS 1397-1993 Steel sheet and strip - Hot-dipped zinc-coated or aluminium/zinc-coated

This document is CITED BY:

AS 1397-1993 Steel sheet and strip - Hot-dipped zinc-coated or aluminium/zinc-coated

Description

This Standard specifies requirements for formable and structural grades of hot-dipped zinc-coated and aluminium/zinc-coated sheet and strip, up to and including 5.0 mm thick. Gives information on coating thickness determination, fabricating characteristics and guidelines on the selection of specific grades.

View on Information Provider website
AS 1397-1993 Steel sheet and strip - Hot-dipped zinc-coated or aluminium/zinc-coated
Description

This Standard specifies requirements for formable and structural grades of hot-dipped zinc-coated and aluminium/zinc-coated sheet and strip, up to and including 5.0 mm thick. Gives information on coating thickness determination, fabricating characteristics and guidelines on the selection of specific grades.

View on Information Provider website
This resource does not cite any other resources.

AS 1397-1993 Steel sheet and strip - Hot-dipped zinc-coated or aluminium/zinc-coated

This resource does not CITE any other resources.
Feedback