AS/NZS 4200.1:1994 Pliable building membranes and underlays - Materials
- Information provider
- Standards New Zealand
- Author
- Standards New Zealand, Standards Australia
- Information type
- New Zealand Standard
- Format
- PDF, HARD COPY
Description
This Standard specifies the requirements for materials suitable for use as a pliable building membrane (also known as underlay) when it is intended to act as a sarking membrane or thermal insulation, or a vapour barrier in a domestic, commercial or industrial building. It does not specify the thermal insulation requirements, nor does it include materials for use in air handling ducts.
Scope
This Standard sets out the requirements for materials suitable for use as a pliable building membrane (also known as underlay) in any of the following circumstances:
- (a) When it is intended to act as a sarking membrane or thermal insulation or a vapour barrier when installed in a building structure.
- (b) When installed either independently, or as a facing to other materials such as insulation materials.
- (c) When installed in domestic, commercial or industrial buildings.
Materials for use in air-handling ducts are generally outside the scope of this Standard. However, this document may be called up by a future the air-handling duct Standard. Vapour barriers used under concrete slabs are outside the scope of this Standard.
This resource is cited by:
AS/NZS 4200.1:1994 Pliable building membranes and underlays - Materials
This document is CITED BY:
-
E2/AS1 (Amd 4) (Third Edition, Amendment 4)
AS/NZS 4200.1:1994 is cited by Acceptable Solution E2/AS1: External Moisture from 28/02/1998
-
AS 2050-2002
AS/NZS 4200.1:1994 is cited by AS 2050-2002 Installation of roof tiles
-
AS 4254.2-2012
AS/NZS 4200.1:1994 is cited by AS 4254.2-2012 Ductwork for air-handling systems in buildings. Part 2: Rigid duct
-
AS/NZS 4859.1:2002
AS/NZS 4200.1:1994 is cited by AS/NZS 4859.1:2002 Materials for the thermal insulation of buildings - General criteria and technical provisions
-
SH/AS1 (First edition, unamended)
AS/NZS 4200.1:1994 is cited by Simple House - Acceptable Solution Revoked
This resource cites:
AS/NZS 4200.1:1994 Pliable building membranes and underlays - Materials
This document CITES:
New Zealand Standards
-
AS/NZS 4201.0:1994
AS/NZS 4200.1:1994 cites AS/NZS 4201.0:1994 Pliable building membranes and underlays - Methods of test - Part 0: General introduction and list of methods
-
AS/NZS 4201.1:1994
AS/NZS 4200.1:1994 cites AS/NZS 4201.1:1994 Pliable building membranes and underlays - Methods of test - Method 1: Resistance to dry delamination
-
AS/NZS 4201.2:1994
AS/NZS 4200.1:1994 cites AS/NZS 4201.2:1994 Pliable building membranes and underlays - Methods of test - Method 2: Resistance to wet delamination
-
AS/NZS 4201.3:1994
AS/NZS 4200.1:1994 cites AS/NZS 4201.3:1994 Pliable building membranes and underlays - Methods of test - Method 3: Shrinkage
-
AS/NZS 4201.4:1994
AS/NZS 4200.1:1994 cites AS/NZS 4201.4:1994 Pliable building membranes and underlays - Methods of test - Method 4: Resistance to water penetration
-
AS/NZS 4201.5:1994
AS/NZS 4200.1:1994 cites AS/NZS 4201.5:1994 Pliable building membranes and underlays - Methods of test - Method 5: Emittance
-
AS/NZS 4201.6:1994
AS/NZS 4200.1:1994 cites AS/NZS 4201.6:1994 Pliable building membranes and underlays - Methods of test - Method 6: Surface water absorbency
Australian Standards
-
AS 1170.2-1989
AS/NZS 4200.1:1994 cites AS 1170.2-1989 Minimum design loads on structures (known as the SAA Loading Code) - Wind loads
-
AS 1199-1988
AS/NZS 4200.1:1994 cites AS 1199-1988 Sampling procedures and tables for inspection by attributes
-
AS 1301.448s-1991
AS/NZS 4200.1:1994 cites AS 1301.448s-1991 Methods of test for pulp and paper - Tensile strength of paper and paperboard (Constant rate of elongation method)
-
AS 1399-1990
AS/NZS 4200.1:1994 cites AS 1399-1990 Guide to AS 1199 - Sampling procedures and tables for inspection by attributes
-
AS 1530.2-1993 (R2016)
AS/NZS 4200.1:1994 cites AS 1530.2-1993 (R2016) Methods for fire tests on building materials, components and structures. Part 2: Test for flammability of materials
-
AS 3900.1-1987
AS/NZS 4200.1:1994 cites AS 3900.1-1987 Quality management and quality assurance Standards - Part 1: Guidelines for selection and use
-
AS 4055-1992
AS/NZS 4200.1:1994 cites AS 4055-1992 Wind loads for housing
Other
-
ASTM E96 - 95
AS/NZS 4200.1:1994 cites ASTM E96 - 95 Standard Test Methods for Water Vapor Transmission of Materials