AS 1397-1993 Steel sheet and strip - Hot-dipped zinc-coated or aluminium/zinc-coated
- Abbreviation
- AS 1397-1993
- Valid from
- 14/06/1993
- Information provider
- Intertek Inform
- Author
- Standards Australia
- Information type
- Australian Standard
- Format
- PDF, HARD COPY
Description
This Standard specifies requirements for formable and structural grades of hot-dipped zinc-coated and aluminium/zinc-coated sheet and strip, up to and including 5.0 mm thick. Gives information on coating thickness determination, fabricating characteristics and guidelines on the selection of specific grades.
Scope
This Standard specifies requirements for steel grades, coating classes and surface finish, as follows:
- (a) Three formability grades of steel.
- (b) Six structural grades of steel.
- (c) Six classes of zinc coating.
- (d) Two classes of zinc coating converted to zinc/iron alloy.
- (e) Two classes of aluminium/zinc alloy coating.
- (f) Surface finish.
Notes:
- Advice and recommendations on information to be supplied by the purchaser at the time of enquiry or order are contained in Appendix A.
- Alternative means for determining compliance with this Standard are given in Appendix B.
- The specified requirements apply to the full length and full width of the product supplied, unless otherwise indicated.
This resource is cited by:
AS 1397-1993 Steel sheet and strip - Hot-dipped zinc-coated or aluminium/zinc-coated
This document is CITED BY:
-
AS/NZS 2699.1:2000
AS 1397-1993 is cited by AS/NZS 2699.1:2000 Built-in components for masonry construction - Wall ties
-
AS/NZS 2699.2:2000
AS 1397-1993 is cited by AS/NZS 2699.2:2000 Built-in components for masonry construction - Connectors and accessories
-
AS/NZS 2904:1995
AS 1397-1993 is cited by AS/NZS 2904:1995 (R2013) Damp-proof courses and flashings