NZS/BS 1449.1.1:1991 Steel plate, sheet and strip - Carbon and carbon-manganese plate, sheet and strip - Part 1.1: General specification

Abbreviation
NZS/BS 1449.1.1:1991
Valid from
31/10/1991

Information provider
Standards New Zealand,
Author
British Standards Institution, Standards New Zealand
Information type
New Zealand Standard,
Format
HARD COPY,


Description

This Standard is based on the BS 1449 series.

It specifies general requirements for flat rolled carbon steel products, available in the hot or cold rolled conditions and in coil or cut length form, rolled as wide strip in nominal widths of 600 mm and wider or as narrow strip in nominal widths less than 600 mm.

Scope

This Standard covers plate, sheet and strip in nominal thicknesses up to and including 16 mm and the material grades, chemical compositions and types of steel.

Requirements are given on the steelmaking process, chemical composition, freedom from defects, condition of material on delivery, number of tests, tensile properties, bending, strain-age-embrittlement, stabilization, formability, hardness, decarburization test, retests, surface finish and surface inspection, edge conditions, tolerances, and inspection and marking.

For assistance with locating previous versions, please contact the information provider.
View on Information Provider website
For assistance with locating previous versions, please contact the information provider.
This resource is cited by:

NZS/BS 1449.1.1:1991 Steel plate, sheet and strip - Carbon and carbon-manganese plate, sheet and strip - Part 1.1: General specification

This document is CITED BY:

NZS/BS 1449.1.1:1991 Steel plate, sheet and strip - Carbon and carbon-manganese plate, sheet and strip - Part 1.1: General specification

Description

This Standard is based on the BS 1449 series.

It specifies general requirements for flat rolled carbon steel products, available in the hot or cold rolled conditions and in coil or cut length form, rolled as wide strip in nominal widths of 600 mm and wider or as narrow strip in nominal widths less than 600 mm.

View on Information Provider website
NZS/BS 1449.1.1:1991 Steel plate, sheet and strip - Carbon and carbon-manganese plate, sheet and strip - Part 1.1: General specification
Description

This Standard is based on the BS 1449 series.

It specifies general requirements for flat rolled carbon steel products, available in the hot or cold rolled conditions and in coil or cut length form, rolled as wide strip in nominal widths of 600 mm and wider or as narrow strip in nominal widths less than 600 mm.

View on Information Provider website
This resource does not cite any other resources.

NZS/BS 1449.1.1:1991 Steel plate, sheet and strip - Carbon and carbon-manganese plate, sheet and strip - Part 1.1: General specification

This resource does not CITE any other resources.
Feedback