ISO 4759-3:2000 Tolerances for fasteners - Part 3: Product grades A and C

Abbreviation
ISO 4759-3:2000
Valid from
11/05/2000

Information provider
Standards New Zealand,
Author
International Standardization Organisations
Information type
ISO Standard,
Format
PDF, HARD COPY,


Description

ISO 4759-3:2016 specifies tolerances for flat washers of product grades A and C  with nominal diameters of 1 mm to 150 mm inclusive, designed to be used in bolted joints in combination with bolts, screws, studs and nuts.

 

Scope

This part of ISO 4759 may be applied to non-flat washers however it does not include all the tolerances related to these washers.

It applies to non-captive and captive washers, and to standard and non-standard washers.

It does not apply to dynamic disc springs.

 

For assistance with locating previous versions, please contact the information provider.
View on Information Provider website
For assistance with locating previous versions, please contact the information provider.
This resource is cited by:

ISO 4759-3:2000 Tolerances for fasteners - Part 3: Product grades A and C

This document is CITED BY:

ISO 4759-3:2000 Tolerances for fasteners - Part 3: Product grades A and C

Description

ISO 4759-3:2016 specifies tolerances for flat washers of product grades A and C  with nominal diameters of 1 mm to 150 mm inclusive, designed to be used in bolted joints in combination with bolts, screws, studs and nuts.

 

View on Information Provider website
ISO 4759-3:2000 Tolerances for fasteners - Part 3: Product grades A and C
Description

ISO 4759-3:2016 specifies tolerances for flat washers of product grades A and C  with nominal diameters of 1 mm to 150 mm inclusive, designed to be used in bolted joints in combination with bolts, screws, studs and nuts.

 

View on Information Provider website
This resource does not cite any other resources.

ISO 4759-3:2000 Tolerances for fasteners - Part 3: Product grades A and C

This resource does not CITE any other resources.
Feedback