ISO 10426-1:2005 Petroleum and natural gas industries — Cements and materials for well cementing — Part 1: Specification

Abbreviation
ISO 10426-1:2005
Valid from
13/12/2005

Information provider
Standards New Zealand,
Author
International Organization for Standardization
Information type
ISO Standard,
Format
PDF, HARD COPY,


Description

This part of ISO 10426 specifies requirements and gives recommendations for eight classes of well cements, including their chemical and physical requirements and procedures for physical testing.

It is applicable to well cement classes A, B, C, D, E and F, which are the products obtained by grinding Portland cement clinker and, if needed, calcium sulfate as an interground additive. Processing additives can be used in the manufacture of cement of these classes.

Suitable set-modifying agents can be interground or blended during manufacture of classes D, E and F.

The first part of ISO 10426 is also applicable to well cement classes G and H, which are the products obtained by grinding Portland cement clinker with no additives other than calcium sulfate or water.

For assistance with locating previous versions, please contact the information provider.
View on Information Provider website
For assistance with locating previous versions, please contact the information provider.
This resource is cited by:

ISO 10426-1:2005 Petroleum and natural gas industries — Cements and materials for well cementing — Part 1: Specification

This document is CITED BY:

ISO 10426-1:2005 Petroleum and natural gas industries — Cements and materials for well cementing — Part 1: Specification

Description

This part of ISO 10426 specifies requirements and gives recommendations for eight classes of well cements, including their chemical and physical requirements and procedures for physical testing.

It is applicable to well cement classes A, B, C, D, E and F, which are the products obtained by grinding Portland cement clinker and, if needed, calcium sulfate as an interground additive. Processing additives can be used in the manufacture of cement of these classes.

Suitable set-modifying agents can be interground or blended during manufacture of classes D, E and F.

The first part of ISO 10426 is also applicable to well cement classes G and H, which are the products obtained by grinding Portland cement clinker with no additives other than calcium sulfate or water.

View on Information Provider website
ISO 10426-1:2005 Petroleum and natural gas industries — Cements and materials for well cementing — Part 1: Specification
Description

This part of ISO 10426 specifies requirements and gives recommendations for eight classes of well cements, including their chemical and physical requirements and procedures for physical testing.

It is applicable to well cement classes A, B, C, D, E and F, which are the products obtained by grinding Portland cement clinker and, if needed, calcium sulfate as an interground additive. Processing additives can be used in the manufacture of cement of these classes.

Suitable set-modifying agents can be interground or blended during manufacture of classes D, E and F.

The first part of ISO 10426 is also applicable to well cement classes G and H, which are the products obtained by grinding Portland cement clinker with no additives other than calcium sulfate or water.

View on Information Provider website
This resource does not cite any other resources.

ISO 10426-1:2005 Petroleum and natural gas industries — Cements and materials for well cementing — Part 1: Specification

This resource does not CITE any other resources.
Feedback