Description

STRUCTAflor is a tongue and groove flooring system that is 19mm thick with a yellow tongue. It is manufactured from high-density reconstituted wood panels.

The panels are produced by bonding radiata pine particles with synthetic resin under heat and pressure, creating a continuous flooring substrate. They are wax-impregnated and edge-sealed for moisture protection.

STRUCTAflor is suitable for use as a structural flooring or flooring substrate.

Scope

1. STRUCTAflor is certified for use in detached dwellings and within household units in multi-unit buildings and within the scope of NZS3604:2011 Timber-framed buildings, where:

• a) Concentrated loads are not greater than 180 kg, and;
• b) Uniformly distributed loads are not greater than 200kg/m2.

2. STRUCTAflor shall be:

• a) Installed in accordance with the STRUCTAflor installation guide February 2026.
• b) Protected by a membrane or other impervious finish when installed in wet and splash areas in accordance with the STRUCTAflor installation guide February 2026.
• c) Not exposed to weather for more than 8 weeks.

3. The subfloor shall be ventilated and protected from external moisture in accordance with the STRUCTAflor installation guide February 2026.

4. The moisture content of STRUCTAflor shall not be more than 18% before sealing or covering with a floor covering.

5. Where STRUCTAflor is used on an access route as defined in Clause A2 of the Building Code it shall be used on a level surface as set out in Table 2 of D1/AS1.