Description

The certificate covers the design (engineering design and specification of lift componentry) and construction (manufacture and installation) of the following Schindler lift models: 2400, 2500, 2600, 3000, 3300, 5000, and 5500.

It is referred to as the Schindler methodology.

Schindler Lifts NZ Ltd design, manufacture, supply and install mechanical lifts in new buildings that comply with B1/VM1 Amd 18 or where an engineer has established that the existing building has sufficient structural integrity to withstand the building work associated with the installation of the lift.

Scope

1. Hydraulic lift installations fall outside the scope of this certificate.

2. This certificate shall only be used as a means of compliance when accompanied by a Schindler Design, Specification and Manufacture Declaration that the specification, design, manufacture is in accordance with the Schindler “’methodology”.

3. Prior to the Code Compliance Certificate being issued, a Schindler Construction CodeMark Declaration shall be provided that confirms the installation is in accordance with the Schindler “methodology”.

4. Schindler Lifts NZ Ltd Maintenance Schedule shall be submitted with the building consent application and incorporated in the compliance schedule.

5. Compliance with D1.3.4 (b) only applies where the lift car has the following internal dimensions:

• a. not less than 1200 x 2100mm, or
• b. not less than 1400 x 1400mm.

6. Where the lift car width is less than 1400mm the lift controls shall be located on the adjacent wall.