BS EN 10226-1:2004 Pipe threads where pressure tight joints are made on the threads - Taper external threads and parallel internal threads. Part 1: Dimensions, tolerances and designation

Abbreviation
BS EN 10226-1:2004
Valid from
30/07/2004

Information provider
British Standards Institution,
Author
British Standards Institution
European Standardization Organisation
Information type
European Standard,
Format
PDF, HARD COPY,


Description

BS EN 10226-1:2004 Pipe threads where pressure tight joints are made on the threads. Taper external threads and parallel internal threads. Dimensions, tolerances and designation.

BS EN 10226-1 specifies the requirements for thread form, dimensions, tolerances and designation for jointing pipe threads, sizes 1/16 to 6 inclusive. It applies to joints made pressure tight by means of mating of the threads. These threads are taper external and parallel internal, and are intended for use with pipes suitable for threading and for valves, fittings or other pipeline equipment interconnected by threaded joints.

An appropriate thread sealant or jointing compound should be used on the thread to ensure pressure-tight joints.

For assistance with locating previous versions, please contact the information provider.
View on Information Provider website
For assistance with locating previous versions, please contact the information provider.
This resource is cited by:

BS EN 10226-1:2004 Pipe threads where pressure tight joints are made on the threads - Taper external threads and parallel internal threads. Part 1: Dimensions, tolerances and designation

This document is CITED BY:

BS EN 10226-1:2004 Pipe threads where pressure tight joints are made on the threads - Taper external threads and parallel internal threads. Part 1: Dimensions, tolerances and designation

Description

BS EN 10226-1:2004 Pipe threads where pressure tight joints are made on the threads. Taper external threads and parallel internal threads. Dimensions, tolerances and designation.

BS EN 10226-1 specifies the requirements for thread form, dimensions, tolerances and designation for jointing pipe threads, sizes 1/16 to 6 inclusive. It applies to joints made pressure tight by means of mating of the threads. These threads are taper external and parallel internal, and are intended for use with pipes suitable for threading and for valves, fittings or other pipeline equipment interconnected by threaded joints.

An appropriate thread sealant or jointing compound should be used on the thread to ensure pressure-tight joints.

View on Information Provider website
BS EN 10226-1:2004 Pipe threads where pressure tight joints are made on the threads - Taper external threads and parallel internal threads. Part 1: Dimensions, tolerances and designation
Description

BS EN 10226-1:2004 Pipe threads where pressure tight joints are made on the threads. Taper external threads and parallel internal threads. Dimensions, tolerances and designation.

BS EN 10226-1 specifies the requirements for thread form, dimensions, tolerances and designation for jointing pipe threads, sizes 1/16 to 6 inclusive. It applies to joints made pressure tight by means of mating of the threads. These threads are taper external and parallel internal, and are intended for use with pipes suitable for threading and for valves, fittings or other pipeline equipment interconnected by threaded joints.

An appropriate thread sealant or jointing compound should be used on the thread to ensure pressure-tight joints.

View on Information Provider website
This resource does not cite any other resources.

BS EN 10226-1:2004 Pipe threads where pressure tight joints are made on the threads - Taper external threads and parallel internal threads. Part 1: Dimensions, tolerances and designation

This resource does not CITE any other resources.
Feedback