ASTM D412 - 06ae2 Standard Test Methods for Vulcanized Rubber and Thermoplastic Elastomers—Tension
- Abbreviation
- ASTM D412 - 06ae2
- Amendment
- Includes amendment 'a' and editorial correction 'e2'
- Valid from
- 10/12/2008
- Information provider
- American Society of Testing and Materials,
- Author
- American Society of Testing and Materials
- Information type
- ASTM Standard,
- Format
- PDF,
Description
These test methods cover procedures used to evaluate the tensile (tension) properties of vulcanized thermoset rubbers and thermoplastic elastomers.
Scope
These test methods cover procedures used to evaluate the tensile (tension) properties of vulcanized thermoset rubbers and thermoplastic elastomers. These methods are not applicable to ebonite and similar hard, low elongation materials. The methods appear as follows:
Test Method A—Dumbbell and Straight Section Specimens | |
Test Method B—Cut Ring Specimens |
Note 1—These two different methods do not produce identical results.
The values stated in either SI or non-SI units shall be regarded separately as normative for this standard. The values in each system may not be exact equivalents; therefore each system must be used independently, without combining values.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
This resource is cited by:
ASTM D412 - 06ae2 Standard Test Methods for Vulcanized Rubber and Thermoplastic Elastomers—Tension
This document is CITED BY:
-
ASTM D6134-07
ASTM D412 - 06ae2 is cited by ASTM D6134-07 Standard Specification for Vulcanised Rubber Sheets Used in Waterproofing Systems