AS/NZS 4548.2:1999 (R2013) Guide to long-life coatings for concrete and masonry - Latex finish coatings - High-build, low profile
- Abbreviation
- AS/NZS 4548.2:1999
- Valid from
- 4/04/1999
- Information provider
- Standards New Zealand,
- Author
- Standards New Zealand, Standards Australia
- Information type
- New Zealand Standard,
- Format
- PDF, HARD COPY,
Description
This Standard provides a guide to the features and typical characteristics of long-life, high-build, low profile latex type finish protective coatings intended for exterior or interior use on concrete and masonry, when applied by airless spray or roller in accordance with the manufacturers instructions.
Scope
Paints covered by this Standard are classified as paint Type 38 of AS 2311 and correspond generally to the Australian Paint Approval Scheme specification Type 3 of GPC-C-117.
High-build, low profile latex finish coatings are water-based coatings that are designed to be used over texture coatings to elevate the exposure performance of the paint system.
These coatings provide a non-aggregate, water-resistant finish which has suitable rheological properties to produce an even film coverage over an irregular surface profile provided by the underlying texture coating. They are used to elevate the performance of the underlying coating and they also provide dirt-shedding and anti-carbonation properties.
These coatings are not intended for use on horizontal surfaces where water ponding is possible. They are normally specified in systems that may have a sealer and multiple coats.
These finish coatings are generally applied by nap roller, but can be airless spray applied, to typically achieve a spreading rate of 1.56.5 m2/L (0.670.15 L/m2). They can be used with a specified primer as stand-alone coatings to provide a low relief texture, such as a stipple finish produced with a nap roller.
This resource is cited by:
AS/NZS 4548.2:1999 (R2013) Guide to long-life coatings for concrete and masonry - Latex finish coatings - High-build, low profile
This document is CITED BY:
-
NZS 3101.1:2006 (inc A1, A2)
AS/NZS 4548.2:1999 is cited by NZS 3101.1:2006 (inc A1, A2) Concrete structures standard. - Part 1: The design of concrete structures. - SPONSORED.
-
NZS 3101.2:2006 (inc A1, A2)
AS/NZS 4548.2:1999 is cited by NZS 3101.2:2006 (inc A1, A2) Concrete structures standard. - Part 2: Commentary on the design of concrete structures. - SPONSORED.
-
NZS 3101.2:2006 (inc A1, A2, A3)
AS/NZS 4548.2:1999 is cited by NZS 3101.2:2006 (inc A1, A2, A3) Concrete structures standard. - Part 2: Commentary on the design of concrete structures. - SPONSORED.