Skip to main content Skip to primary navigation
Resource detail
Citations

AS/NZS 1462.1:1996 Methods of test for plastics pipes and fittings - Method 1: Method for determining the dimensions of pipes and fittings

View on Information Provider website
Abbreviation
AS/NZS 1462.1:1996
Valid from
4/04/1996
Information provider
Standards New Zealand,
Author
Standards New Zealand, Standards Australia
Information type
New Zealand Standard,
Cited By
This resource is cited by 1 document (show Citations)
Description

This Method sets out the procedure for determining the dimensions of PVC pipes and fittings, i.e. outside diameter wall thickness, length, squareness of pipe ends and internal length, mouth diameter and root diameter of sockets. Other methods, which can be shown to provide an accuracy of the same or of a higher degree, may be used.

For assistance with locating previous versions, please contact the information provider.
View on Information Provider website
For assistance with locating previous versions, please contact the information provider.
This resource is cited by:

AS/NZS 1462.1:1996 Methods of test for plastics pipes and fittings - Method 1: Method for determining the dimensions of pipes and fittings

This document is CITED BY:

AS/NZS 1462.1:1996 Methods of test for plastics pipes and fittings - Method 1: Method for determining the dimensions of pipes and fittings

Description

This Method sets out the procedure for determining the dimensions of PVC pipes and fittings, i.e. outside diameter wall thickness, length, squareness of pipe ends and internal length, mouth diameter and root diameter of sockets. Other methods, which can be shown to provide an accuracy of the same or of a higher degree, may be used.

View on Information Provider website
AS/NZS 1462.1:1996 Methods of test for plastics pipes and fittings - Method 1: Method for determining the dimensions of pipes and fittings
Description

This Method sets out the procedure for determining the dimensions of PVC pipes and fittings, i.e. outside diameter wall thickness, length, squareness of pipe ends and internal length, mouth diameter and root diameter of sockets. Other methods, which can be shown to provide an accuracy of the same or of a higher degree, may be used.

View on Information Provider website
This resource does not cite any other resources.

AS/NZS 1462.1:1996 Methods of test for plastics pipes and fittings - Method 1: Method for determining the dimensions of pipes and fittings

This resource does not CITE any other resources.
Feedback