AS 2382-1981 Surface roughness comparison specimens
- Abbreviation
- AS 2382-1981
- Valid from
- 15/12/1980
- Information provider
- Intertek Inform,
- Author
- Standards Australia
- Information type
- Australian Standard,
- Format
- PDF, HARD COPY,
Description
This standard specifies the characteristics of surface roughness comparison specimens intended for tactile and visual comparison with workpiece surfaces produced by similar processes.
Roughness comparison specimens for the following processes are given:
- Turned, ground, bored, milled, shaped or planed specimens;
- Spark-eroded, shot blasted, grit blasted, or polished specimens;
- Specimens for cast surfaces;
- Calibration of surface roughness specimens.
The standard also includes definitions used in surface roughness and gives information on cut-off lengths and marking requirements.
Appendices give information on typical sets of mounted roughness comparison specimens, the use of roughness comparison specimens, roughness grade numbers and roughness average values of Ra (arithmetic mean deviation) in both metric and the corresponding imperial units.
This resource is cited by:
AS 2382-1981 Surface roughness comparison specimens
This document is CITED BY:
-
AS/NZS 3879:2011
AS 2382-1981 is cited by AS/NZS 3879:2011 Solvent cements and priming fluids for PVC (PVC-U and PVC-M) and ABS and ASA pipes and fittings
-
NZS 3404 Parts 1 and 2:1997
AS 2382-1981 is cited by NZS 3404 Parts 1 and 2:1997 Steel structures standard - SPONSORED