AS 2101-1978 Internal micrometers (including stick micrometers) (metric series)
- Abbreviation
- AS 2101-1978
- Valid from
- 1/07/1978
- Information provider
- Intertek Inform,
- Author
- Standards Australia
- Information type
- Australian Standard,
- Format
- PDF, HARD COPY,
Description
This Standard specifies internal micrometers and stick micrometers reading to 0.01 mm and gives requirements for materials, properties, basic design details, accuracy and finish. An appendix gives notes on the assessment of the more important features of these instruments.
For internal micrometers, sizes up to 900 mm and for stick micrometers sizes up to 1800 mm are covered. Requirements for setting gauges for use with these measuring instruments are also given.
Scope
This standard applies to internal micrometers, including stick micrometers, reading to 0.01 mm. It specifies materials and properties, design requirements and general dimensions, and also the setting gauges for stick micrometers, but it does not cover three-point contact bore micrometers used for other types of internal measurement.
Appendix A sets out recommended methods of test for the more important metrological features.
This resource is cited by:
AS 2101-1978 Internal micrometers (including stick micrometers) (metric series)
This document is CITED BY:
-
AS/NZS 2280:2014
AS 2101-1978 is cited by AS/NZS 2280:2014 Ductile iron pipes and fittings