AS 1654.2-1995 ISO system of limits and fits - Tables of standard tolerance grades and limit deviations for holes and shafts

Abbreviation
AS 1654.2-1995
Valid from
5/12/1995

Information provider
Intertek Inform,
Author
Standards Australia
Information type
Australian Standard,
Format
PDF, HARD COPY,


Description

This Standard gives values of the limit deviations for commonly used tolerance class for holes and shafts in machined workpieces calculated from the information given in AS 1654.1.

Graphical representations of tolerance zones are given in the Annex.

Identical with and reproduced from ISO 286-2:1988.

Scope

This part of ISO 286 gives values of the limit deviations for commonly used tolerance classes (zones) for holes and shafts calculated from the information given in ISO 286. It covers values for the upper deviations ES (for holes) and es (for shafts), and the lower deviations EI (for holes) and ei (for shafts) (see figure 1).

Note - In the tables of limit deviations, the values for the upper deviation ES or es are shown above the values for the lower deviation EI or ei except for tolerance class JS and js which is symmetrical about the zero line.

For assistance with locating previous versions, please contact the information provider.
View on Information Provider website
For assistance with locating previous versions, please contact the information provider.
This resource is cited by:

AS 1654.2-1995 ISO system of limits and fits - Tables of standard tolerance grades and limit deviations for holes and shafts

This document is CITED BY:

AS 1654.2-1995 ISO system of limits and fits - Tables of standard tolerance grades and limit deviations for holes and shafts

Description

This Standard gives values of the limit deviations for commonly used tolerance class for holes and shafts in machined workpieces calculated from the information given in AS 1654.1.

Graphical representations of tolerance zones are given in the Annex.

Identical with and reproduced from ISO 286-2:1988.

View on Information Provider website
AS 1654.2-1995 ISO system of limits and fits - Tables of standard tolerance grades and limit deviations for holes and shafts
Description

This Standard gives values of the limit deviations for commonly used tolerance class for holes and shafts in machined workpieces calculated from the information given in AS 1654.1.

Graphical representations of tolerance zones are given in the Annex.

Identical with and reproduced from ISO 286-2:1988.

View on Information Provider website
This resource does not cite any other resources.

AS 1654.2-1995 ISO system of limits and fits - Tables of standard tolerance grades and limit deviations for holes and shafts

This resource does not CITE any other resources.
Feedback