AS 1594-1992 Hot-rolled steel flat products

Abbreviation
AS 1594-1992
Valid from
17/01/1992

Information provider
Intertek Inform,
Author
Standards Australia
Information type
Australian Standard,
Format
PDF, HARD COPY,


Description

This Standard specifies requirements for hot-rolled steel plate, floorplate, sheet and strip, rolled on a continuous mill, in thicknesses up to 13 mm and widths up to 2000 mm. It includes slit material, provided that the parent material has an as-rolled width of not less than 600 mm.

Scope

The Standard specifies the following grade requirements:

  • (a) For analysis grades: chemical composition only.
  • (b) For formability grades, extra formability grades, and structural grades including weather-resistant grades: both chemical composition and mechanical properties.
  • (c) For floorplate: both chemical composition and mechanical properties.

The Standard permits the addition of boron and micro-alloying elements for the achievement of special properties.

NOTES:

  1. This Standard does not cover the following-
    • (a) steel plate for boilers and pressure vessels (see AS 1548); and
    • (b) hot-rolled structural steel plates, floorplates and slabs (see AS 3678).
  2. Advice and recommendations on information to be supplied by the purchaser at the time of enquiry or order are contained in: the purchasing guidelines set out in Appendix A.
  3. Alternative means for demonstrating compliance with this Standard are given in Appendix B
For assistance with locating previous versions, please contact the information provider.
View on Information Provider website
For assistance with locating previous versions, please contact the information provider.
This resource is cited by:

AS 1594-1992 Hot-rolled steel flat products

This document is CITED BY:

AS 1594-1992 Hot-rolled steel flat products

Description

This Standard specifies requirements for hot-rolled steel plate, floorplate, sheet and strip, rolled on a continuous mill, in thicknesses up to 13 mm and widths up to 2000 mm. It includes slit material, provided that the parent material has an as-rolled width of not less than 600 mm.

View on Information Provider website
AS 1594-1992 Hot-rolled steel flat products
Description

This Standard specifies requirements for hot-rolled steel plate, floorplate, sheet and strip, rolled on a continuous mill, in thicknesses up to 13 mm and widths up to 2000 mm. It includes slit material, provided that the parent material has an as-rolled width of not less than 600 mm.

View on Information Provider website
This resource does not cite any other resources.

AS 1594-1992 Hot-rolled steel flat products

This resource does not CITE any other resources.
Feedback