Save

AS 2382-1981 Surface roughness comparison specimens

Abbreviation
AS 2382-1981
Valid from
15/12/1980

Information provider
SAI Global
Author
Standards Australia
Information type
Australian Standard
Format
PDF


Description

This standard specifies the characteristics of surface roughness comparison specimens intended for tactile and visual comparison with workpiece surfaces produced by similar processes.

Roughness comparison specimens for the following processes are given:

  • Turned, ground, bored, milled, shaped or planed specimens;
  • Spark-eroded, shot blasted, grit blasted, or polished specimens;
  • Specimens for cast surfaces;
  • Calibration of surface roughness specimens.

The standard also includes definitions used in surface roughness and gives information on cut-off lengths and marking requirements.

Appendices give information on typical sets of mounted roughness comparison specimens, the use of roughness comparison specimens, roughness grade numbers and roughness average values of Ra (arithmetic mean deviation) in both metric and the corresponding imperial units.

For assistance with locating previous versions, please contact the information provider.
View on Information Provider website
For assistance with locating previous versions, please contact the information provider.
This resource is cited by:

AS 2382-1981 Surface roughness comparison specimens

This document is CITED BY:

AS 2382-1981 Surface roughness comparison specimens

Description

This standard specifies the characteristics of surface roughness comparison specimens intended for tactile and visual comparison with workpiece surfaces produced by similar processes.

Roughness comparison specimens for the following processes are given:

  • Turned, ground, bored, milled, shaped or planed specimens;
  • Spark-eroded, shot blasted, grit blasted, or polished specimens;
  • Specimens for cast surfaces;
  • Calibration of surface roughness specimens.

The standard also includes definitions used in surface roughness and gives information on cut-off lengths and marking requirements.

Appendices give information on typical sets of mounted roughness comparison specimens, the use of roughness comparison specimens, roughness grade numbers and roughness average values of Ra (arithmetic mean deviation) in both metric and the corresponding imperial units.

View on Information Provider website
AS 2382-1981 Surface roughness comparison specimens
Description

This standard specifies the characteristics of surface roughness comparison specimens intended for tactile and visual comparison with workpiece surfaces produced by similar processes.

Roughness comparison specimens for the following processes are given:

  • Turned, ground, bored, milled, shaped or planed specimens;
  • Spark-eroded, shot blasted, grit blasted, or polished specimens;
  • Specimens for cast surfaces;
  • Calibration of surface roughness specimens.

The standard also includes definitions used in surface roughness and gives information on cut-off lengths and marking requirements.

Appendices give information on typical sets of mounted roughness comparison specimens, the use of roughness comparison specimens, roughness grade numbers and roughness average values of Ra (arithmetic mean deviation) in both metric and the corresponding imperial units.

View on Information Provider website
This resource does not cite any other resources.

AS 2382-1981 Surface roughness comparison specimens

This resource does not CITE any other resources.
Save
Feedback