AS 2331.1.7-2006 (R2017) Methods of test for metallic and related coatings - Local thickness tests - Measurement of dry film thickness of thin coating systems particularly by coil coated products by destructive means using a boring device

Abbreviation
AS 2331.1.7-2006
Valid from
14/08/2006

Information provider
Intertek Inform
Author
Standards Australia
Information type
Australian Standard
Format
PDF, HARD COPY


Description

This standard specifies a method for determining the measurement of dry film thickness, of coating films by microscopic observation and of a precision-cut shallow-angle crater in the coating film.

The substrate may be any rigid, metallic material, for example, cold-rolled steel, hot-dip galvanized steel, aluminium, etc. The substrate should be planar.

Scope

NOTE: Variations in the surface profile of the substrate may result in non-representative organic coating thickness readings. This condition may exist over substrates such as hot-dip, coated steel sheet. This is true of all precision cut methods that are used to determine dry film thickness of organic coatings.

This method is only valid for coating thicknesses between 0 to 90 m, for measurements of films greater than 90 m but less than 1575 m, a 45 borer may be used in accordance with this test method.

For assistance with locating previous versions, please contact the information provider.
View on Information Provider website
For assistance with locating previous versions, please contact the information provider.
This resource is cited by:

AS 2331.1.7-2006 (R2017) Methods of test for metallic and related coatings - Local thickness tests - Measurement of dry film thickness of thin coating systems particularly by coil coated products by destructive means using a boring device

This document is CITED BY:

AS 2331.1.7-2006 (R2017) Methods of test for metallic and related coatings - Local thickness tests - Measurement of dry film thickness of thin coating systems particularly by coil coated products by destructive means using a boring device

Description

This standard specifies a method for determining the measurement of dry film thickness, of coating films by microscopic observation and of a precision-cut shallow-angle crater in the coating film.

The substrate may be any rigid, metallic material, for example, cold-rolled steel, hot-dip galvanized steel, aluminium, etc. The substrate should be planar.

View on Information Provider website
AS 2331.1.7-2006 (R2017) Methods of test for metallic and related coatings - Local thickness tests - Measurement of dry film thickness of thin coating systems particularly by coil coated products by destructive means using a boring device
Description

This standard specifies a method for determining the measurement of dry film thickness, of coating films by microscopic observation and of a precision-cut shallow-angle crater in the coating film.

The substrate may be any rigid, metallic material, for example, cold-rolled steel, hot-dip galvanized steel, aluminium, etc. The substrate should be planar.

View on Information Provider website
This resource does not cite any other resources.

AS 2331.1.7-2006 (R2017) Methods of test for metallic and related coatings - Local thickness tests - Measurement of dry film thickness of thin coating systems particularly by coil coated products by destructive means using a boring device

This resource does not CITE any other resources.
Feedback