AS/NZS 4158:2003 Thermal-bonded polymeric coatings on valves and fittings for water industry purposes

Abbreviation
AS/NZS 4158:2003
Amendment
Amendment 1 - incorporated, published 29/09/2005.
Valid from
4/03/2003

Information provider
Standards New Zealand,
Author
Standards New Zealand, Standards Australia
Information type
New Zealand Standard,


Description

This Standard specifies the requirements for factory-applied thermal-bonded polymeric corrosion protective coatings (barrier coatings). For the purposes of this Standard, the term polymeric coating is intended to encompass both thermoplastic and thermosetting coating materials, which are used to coat both the internal and external surfaces of valves and fittings.

Scope

This Standard covers the following service application areas:

  • (a) Factory-applied coatings and associated coatings used for repair.
  • (b) Ductile iron, grey cast iron, malleable iron, steel and copper alloy based substrates.
  • (c) Valves, fittings and their components and associated equipment.
  • (d) Contact with water, and wastewater up to 50°C.
  • (e) Above and below ground exposure.

Means of demonstrating compliance with this Standard are given in Appendix B.

For assistance with locating previous versions, please contact the information provider.
View on Information Provider website
For assistance with locating previous versions, please contact the information provider.
This resource is cited by:

AS/NZS 4158:2003 Thermal-bonded polymeric coatings on valves and fittings for water industry purposes

This document is CITED BY:

AS/NZS 4158:2003 Thermal-bonded polymeric coatings on valves and fittings for water industry purposes

Description

This Standard specifies the requirements for factory-applied thermal-bonded polymeric corrosion protective coatings (barrier coatings). For the purposes of this Standard, the term polymeric coating is intended to encompass both thermoplastic and thermosetting coating materials, which are used to coat both the internal and external surfaces of valves and fittings.

View on Information Provider website
AS/NZS 4158:2003 Thermal-bonded polymeric coatings on valves and fittings for water industry purposes
Description

This Standard specifies the requirements for factory-applied thermal-bonded polymeric corrosion protective coatings (barrier coatings). For the purposes of this Standard, the term polymeric coating is intended to encompass both thermoplastic and thermosetting coating materials, which are used to coat both the internal and external surfaces of valves and fittings.

View on Information Provider website
This resource does not cite any other resources.

AS/NZS 4158:2003 Thermal-bonded polymeric coatings on valves and fittings for water industry purposes

This resource does not CITE any other resources.
Feedback