WTIA Technical Note 05 – Flame Cutting of Steels (1994)

Abbreviation
WTIA TN 05
Valid from
1/01/1994

Information provider
Welding Technology Institute of Australia,
Author
Welding Technology Institute of Australia
Information type
Technical guidance,
Format
PDF,


Description

This Technical Note 05 gives a wealth of practical guidance on flame cutting including detailed procedures for efficient cutting, selection of equipment and gases, practices for identifying and curing defective cutting, methods of maximising economy and other important guidance on the use of steels with flame cut surfaces.

For assistance with locating previous versions, please contact the information provider.
View on Information Provider website
For assistance with locating previous versions, please contact the information provider.
This resource is cited by:

WTIA Technical Note 05 – Flame Cutting of Steels (1994)

This document is CITED BY:

WTIA Technical Note 05 – Flame Cutting of Steels (1994)

Description

This Technical Note 05 gives a wealth of practical guidance on flame cutting including detailed procedures for efficient cutting, selection of equipment and gases, practices for identifying and curing defective cutting, methods of maximising economy and other important guidance on the use of steels with flame cut surfaces.

View on Information Provider website
WTIA Technical Note 05 – Flame Cutting of Steels (1994)
Description

This Technical Note 05 gives a wealth of practical guidance on flame cutting including detailed procedures for efficient cutting, selection of equipment and gases, practices for identifying and curing defective cutting, methods of maximising economy and other important guidance on the use of steels with flame cut surfaces.

View on Information Provider website
This resource does not cite any other resources.

WTIA Technical Note 05 – Flame Cutting of Steels (1994)

This resource does not CITE any other resources.
Feedback