ISO 580:2005 Plastics piping and ducting systems - Injection-moulded thermoplastics fittings - Methods for visually assessing the effects of heating

Abbreviation
ISO 580:2005
Valid from
7/03/2005

Information provider
Standards New Zealand
Author
International Organization for Standardization
Information type
ISO Standard
Format
PDF, HARD COPY


Description

This standard specifies two methods for assessing the effects of heating on injection-moulded thermoplastics pipe fittings.

Scope

This International Standard specifies two methods for assessing the effects of heating on injection-moulded thermoplastics pipe fittings;

  • method A, using an air oven, and
  • method B, using a liquid bath.

In case of disagreement, method A is the reference method.

This International Standard is applicable to cement-welded fittings as well as to flanged fittings and fittings incorporating elastomeric seals and to fittings consisting of the assembly of several moulded parts (e.g. union connectors). It is applicable to both pressure and non-pressure fittings.

For assistance with locating previous versions, please contact the information provider.
View on Information Provider website
For assistance with locating previous versions, please contact the information provider.
This resource is cited by:

ISO 580:2005 Plastics piping and ducting systems - Injection-moulded thermoplastics fittings - Methods for visually assessing the effects of heating

This document is CITED BY:

ISO 580:2005 Plastics piping and ducting systems - Injection-moulded thermoplastics fittings - Methods for visually assessing the effects of heating

Description

This standard specifies two methods for assessing the effects of heating on injection-moulded thermoplastics pipe fittings.

View on Information Provider website
ISO 580:2005 Plastics piping and ducting systems - Injection-moulded thermoplastics fittings - Methods for visually assessing the effects of heating
Description

This standard specifies two methods for assessing the effects of heating on injection-moulded thermoplastics pipe fittings.

View on Information Provider website
This resource does not cite any other resources.

ISO 580:2005 Plastics piping and ducting systems - Injection-moulded thermoplastics fittings - Methods for visually assessing the effects of heating

This resource does not CITE any other resources.
Feedback