ISO 23711:2003 Elastomeric seals - Requirements for materials for pipe joint seals used in water and drainage applications - Thermoplastic elastomers

Abbreviation
ISO 23711:2003
Valid from
26/11/2003

Information provider
Standards New Zealand
Author
International Organization for Standardization
Information type
ISO Standard
Format
PDF, HARD COPY


Description

ISO 23711:2003 specifies requirements for materials used for moulded seals made of thermoplastic elastomers (TPEs) for joints in:

  1. thermoplastic piping systems for non-pressure waste water discharge (intermittent flow at up to 95°C) inside buildings;
  2. thermoplastic piping systems for non-pressure underground drainage and sewerage (continuous flow at up to 45°C and intermittent flow at up to 95°C);
  3. thermoplastic rainwater piping systems. General requirements for finished joint seals are also given; any additional requirements called for by the particular application are specified in the relevant product standards taking into account that the performance of pipe joints is a function of the seal material properties, seal geometry and pipe joint design.

For assistance with locating previous versions, please contact the information provider.
View on Information Provider website
For assistance with locating previous versions, please contact the information provider.
This resource is cited by:

ISO 23711:2003 Elastomeric seals - Requirements for materials for pipe joint seals used in water and drainage applications - Thermoplastic elastomers

This document is CITED BY:

ISO 23711:2003 Elastomeric seals - Requirements for materials for pipe joint seals used in water and drainage applications - Thermoplastic elastomers

Description

ISO 23711:2003 specifies requirements for materials used for moulded seals made of thermoplastic elastomers (TPEs) for joints in:

  1. thermoplastic piping systems for non-pressure waste water discharge (intermittent flow at up to 95°C) inside buildings;
  2. thermoplastic piping systems for non-pressure underground drainage and sewerage (continuous flow at up to 45°C and intermittent flow at up to 95°C);
  3. thermoplastic rainwater piping systems. General requirements for finished joint seals are also given; any additional requirements called for by the particular application are specified in the relevant product standards taking into account that the performance of pipe joints is a function of the seal material properties, seal geometry and pipe joint design.

View on Information Provider website
ISO 23711:2003 Elastomeric seals - Requirements for materials for pipe joint seals used in water and drainage applications - Thermoplastic elastomers
Description

ISO 23711:2003 specifies requirements for materials used for moulded seals made of thermoplastic elastomers (TPEs) for joints in:

  1. thermoplastic piping systems for non-pressure waste water discharge (intermittent flow at up to 95°C) inside buildings;
  2. thermoplastic piping systems for non-pressure underground drainage and sewerage (continuous flow at up to 45°C and intermittent flow at up to 95°C);
  3. thermoplastic rainwater piping systems. General requirements for finished joint seals are also given; any additional requirements called for by the particular application are specified in the relevant product standards taking into account that the performance of pipe joints is a function of the seal material properties, seal geometry and pipe joint design.
View on Information Provider website
This resource does not cite any other resources.

ISO 23711:2003 Elastomeric seals - Requirements for materials for pipe joint seals used in water and drainage applications - Thermoplastic elastomers

This resource does not CITE any other resources.
Feedback