AS 1101.3-1987 Graphical symbols for general engineering - Part 3: Welding and non-destructive examination

Abbreviation
AS 1101.3-1987
Valid from
6/02/1987

Information provider
Intertek Inform,
Author
Standards Australia
Information type
Australian Standard,
Format
PDF, HARD COPY,


Description

This Standard specifies symbols which provide the means of placing complete welding information on drawings. It describes the application of these symbols and illustrated examples for their use in various welding processes. A separate section covers the symbols to be used on drawings to specify non-destructive examination requirements.

Scope

This standard describes symbols which provide the means of placing complete welding information on drawings. It covers the details and application of symbols related to various welding processes (including brazing), and non-destructive examination.

Appendix A gives a listing of abbreviations normally used for welding and allied processes. Appendix B shows the design of standard symbols, while Appendix C gives a typical example for the use of symbols on structural drawings.

For assistance with locating previous versions, please contact the information provider.
View on Information Provider website
For assistance with locating previous versions, please contact the information provider.
This resource is cited by:

AS 1101.3-1987 Graphical symbols for general engineering - Part 3: Welding and non-destructive examination

This document is CITED BY:

AS 1101.3-1987 Graphical symbols for general engineering - Part 3: Welding and non-destructive examination

Description

This Standard specifies symbols which provide the means of placing complete welding information on drawings. It describes the application of these symbols and illustrated examples for their use in various welding processes. A separate section covers the symbols to be used on drawings to specify non-destructive examination requirements.

View on Information Provider website
AS 1101.3-1987 Graphical symbols for general engineering - Part 3: Welding and non-destructive examination
Description

This Standard specifies symbols which provide the means of placing complete welding information on drawings. It describes the application of these symbols and illustrated examples for their use in various welding processes. A separate section covers the symbols to be used on drawings to specify non-destructive examination requirements.

View on Information Provider website
This resource does not cite any other resources.

AS 1101.3-1987 Graphical symbols for general engineering - Part 3: Welding and non-destructive examination

This resource does not CITE any other resources.
Feedback