Rockcote Resene Monotek® Systems
- Abbreviation
- Appraisal number 500
- Amendment
- 15 March 2018
- Valid from
- 26/09/2007
- Information provider
- BRANZ Limited
- Information type
- BRANZ Appraisal
- Format
Description
The Rockcote Resene Monotek® Systems consists of the Rockcote Resene Monotek® Texture System and the Rockcote Resene Monotek® Render System, which are jointing and coating systems for use as finishing systems for Monotek® Sheet - Cavity Construction.
The Rockcote Resene Monotek® Texture System consists of a fibreglass mesh reinforced jointing plaster followed by a mineral filled, polymer-based, elastomeric high build pre-coloured coating.
The Rockcote Resene Monotek® Render System consists of a fibreglass mesh reinforced jointing plaster, a cement based polymer modified levelling coat to the entire sheet surface, followed by a mineral filled, polymer-based, high build trowel applied precoloured texture coating. The plaster system is finished with Resene X200 waterproof membrane.
Scope
The Rockcote Resene Monotek® Systems have been appraised for use as jointing and coating systems for Monotek® Sheet - Cavity Construction on buildings within the following scope:
- the scope limitations of NZBC Acceptable Solution E2/AS1; and,
- with a risk score of 0-20, calculated in accordance with NZBC Acceptable Solution E2/AS1, Table 2; and
- situated in NZS 3604 Wind Zones up to, and including ‘Extra High’.
The Rockcote Resene Monotek® Systems have also been appraised for use as jointing and coating systems for Monotek® Sheet - Cavity Construction on buildings subject to specific design up to an ultimate limit state (ULS) wind pressure of 2500 Pa; and,
- constructed with timber framing complying with the NZBC; and,
- within the scope limitations of BRANZ Appraisal No. 466 (2005) Monotek® Sheet - Cavity Construction.
Monotek® Sheet - Cavity Construction must be used, designed and installed as described in BRANZ Appraisal No. 466 (2005) and the Monotek® Sheet - Cavity Construction Technical Literature.
Installation of components and accessories supplied by Rockcote Resene Limited must be carried out only by Rockcote Resene Limited Registered Applicators.