ISO 3302-1:1996 Rubber - Tolerances for products - Part 1: Dimensional tolerances

Abbreviation
ISO 3302-1:1996
Amendment
ISO 3302-1:1996/Amd 1:2001
Valid from
18/07/1996

Information provider
Standards New Zealand,
Author
International Organization for Standardization
Information type
ISO Standard,
Format
PDF, HARD COPY,


Description

This part of ISO 3302 specifies classes of dimensional tolerances, and their values, for moulded, extruded and calendered solid rubber products. The relevant test methods necessary for the establishment of compliance with this International Standard are also specified. The tolerances are primarily intended for use with vulcanized rubber but may also be suitable for products made of thermoplastic rubbers.
  • This part of ISO 3302 does not apply to precision toroidal sealing rings or to calendered composite products such as rubber-coated fabrics or products where a rubber coating is applied by the process of topping or skim coating.

For assistance with locating previous versions, please contact the information provider.
View on Information Provider website
For assistance with locating previous versions, please contact the information provider.
This resource is cited by:

ISO 3302-1:1996 Rubber - Tolerances for products - Part 1: Dimensional tolerances

This document is CITED BY:

ISO 3302-1:1996 Rubber - Tolerances for products - Part 1: Dimensional tolerances

Description

This part of ISO 3302 specifies classes of dimensional tolerances, and their values, for moulded, extruded and calendered solid rubber products. The relevant test methods necessary for the establishment of compliance with this International Standard are also specified. The tolerances are primarily intended for use with vulcanized rubber but may also be suitable for products made of thermoplastic rubbers.
  • This part of ISO 3302 does not apply to precision toroidal sealing rings or to calendered composite products such as rubber-coated fabrics or products where a rubber coating is applied by the process of topping or skim coating.

View on Information Provider website
ISO 3302-1:1996 Rubber - Tolerances for products - Part 1: Dimensional tolerances
Description
This part of ISO 3302 specifies classes of dimensional tolerances, and their values, for moulded, extruded and calendered solid rubber products. The relevant test methods necessary for the establishment of compliance with this International Standard are also specified. The tolerances are primarily intended for use with vulcanized rubber but may also be suitable for products made of thermoplastic rubbers.
  • This part of ISO 3302 does not apply to precision toroidal sealing rings or to calendered composite products such as rubber-coated fabrics or products where a rubber coating is applied by the process of topping or skim coating.
View on Information Provider website
This resource does not cite any other resources.

ISO 3302-1:1996 Rubber - Tolerances for products - Part 1: Dimensional tolerances

This resource does not CITE any other resources.
Feedback