ISO 23711:2003 Elastomeric seals - Requirements for materials for pipe joint seals used in water and drainage applications - Thermoplastic elastomers

ISO 23711:2003 specifies requirements for materials used for moulded seals made of thermoplastic elastomers (TPEs) for joints in:

thermoplastic piping systems for non-pressure waste water discharge (intermittent flow at up to 95°C) inside buildings;
thermoplastic piping systems for non-pressure underground drainage and sewerage (continuous flow at up to 45°C and intermittent flow at up to 95°C);
thermoplastic rainwater piping systems. General requirements for finished joint seals are also given; any additional requirements called for by the particular application are specified in the relevant product standards taking into account that the performance of pipe joints is a function of the seal material properties, seal geometry and pipe joint design.

View on Information Provider website

AS/NZS 4401:2006

ISO 23711:2003 is cited by AS/NZS 4401:2006 (R2016) Plastics piping systems for soil and waste discharge (low and high temperature) inside buildings - Polyethylene (PE)

ISO 23711:2003 specifies requirements for materials used for moulded seals made of thermoplastic elastomers (TPEs) for joints in:

thermoplastic piping systems for non-pressure waste water discharge (intermittent flow at up to 95°C) inside buildings;
thermoplastic piping systems for non-pressure underground drainage and sewerage (continuous flow at up to 45°C and intermittent flow at up to 95°C);
thermoplastic rainwater piping systems. General requirements for finished joint seals are also given; any additional requirements called for by the particular application are specified in the relevant product standards taking into account that the performance of pipe joints is a function of the seal material properties, seal geometry and pipe joint design.

View on Information Provider website

ISO 23711:2003 specifies requirements for materials used for moulded seals made of thermoplastic elastomers (TPEs) for joints in:

thermoplastic piping systems for non-pressure waste water discharge (intermittent flow at up to 95°C) inside buildings;
thermoplastic piping systems for non-pressure underground drainage and sewerage (continuous flow at up to 45°C and intermittent flow at up to 95°C);
thermoplastic rainwater piping systems. General requirements for finished joint seals are also given; any additional requirements called for by the particular application are specified in the relevant product standards taking into account that the performance of pipe joints is a function of the seal material properties, seal geometry and pipe joint design.

View on Information Provider website

Feedback