Save

BS EN 10029:1991 Specification for tolerances on dimensions, shape and mass for hot rolled steel plates 3 mm thick or above

Abbreviation
BS EN 10029:1991
Valid from
31/10/1991

Information provider
Standards New Zealand
Author
British Standards Institution
Information type
British Standard
Format
PDF


Description

This European Standard specifies requirements for tolerances for hot-rolled non-alloy and alloy steel plates including stainless steels with the following characteristics: 

  • a) nominal thickness ≥ 3 mm ≤ 250 mm;
  • b) nominal width ≥ 600 mm;
  • c) specified minimum yield strength < 700 N/mm2.

Tolerances for products of width < 600 mm cut or slit from plate should be agreed between manufacturer and purchaser at the time of enquiry and order.

This European Standard does not apply to round plates, sketch plates, chequer or raised-droplet pattern floor plates and wide flats for which other EURONORMS exist or European Standards dealing with tolerances on products of steel are being prepared:

  • tolerances on dimensions, shape and mass for hot-rolled wide flats of steel (see EURONORM 91)

For assistance with locating previous versions, please contact the information provider.
View on Information Provider website
For assistance with locating previous versions, please contact the information provider.
This resource is cited by:

BS EN 10029:1991 Specification for tolerances on dimensions, shape and mass for hot rolled steel plates 3 mm thick or above

This document is CITED BY:

BS EN 10029:1991 Specification for tolerances on dimensions, shape and mass for hot rolled steel plates 3 mm thick or above

Description

This European Standard specifies requirements for tolerances for hot-rolled non-alloy and alloy steel plates including stainless steels with the following characteristics: 

  • a) nominal thickness ≥ 3 mm ≤ 250 mm;
  • b) nominal width ≥ 600 mm;
  • c) specified minimum yield strength < 700 N/mm2.

Tolerances for products of width < 600 mm cut or slit from plate should be agreed between manufacturer and purchaser at the time of enquiry and order.

This European Standard does not apply to round plates, sketch plates, chequer or raised-droplet pattern floor plates and wide flats for which other EURONORMS exist or European Standards dealing with tolerances on products of steel are being prepared:

  • tolerances on dimensions, shape and mass for hot-rolled wide flats of steel (see EURONORM 91)

View on Information Provider website
BS EN 10029:1991 Specification for tolerances on dimensions, shape and mass for hot rolled steel plates 3 mm thick or above
Description

This European Standard specifies requirements for tolerances for hot-rolled non-alloy and alloy steel plates including stainless steels with the following characteristics: 

  • a) nominal thickness ≥ 3 mm ≤ 250 mm;
  • b) nominal width ≥ 600 mm;
  • c) specified minimum yield strength < 700 N/mm2.

Tolerances for products of width < 600 mm cut or slit from plate should be agreed between manufacturer and purchaser at the time of enquiry and order.

This European Standard does not apply to round plates, sketch plates, chequer or raised-droplet pattern floor plates and wide flats for which other EURONORMS exist or European Standards dealing with tolerances on products of steel are being prepared:

  • tolerances on dimensions, shape and mass for hot-rolled wide flats of steel (see EURONORM 91)
View on Information Provider website
This resource does not cite any other resources.

BS EN 10029:1991 Specification for tolerances on dimensions, shape and mass for hot rolled steel plates 3 mm thick or above

This resource does not CITE any other resources.
Save
Feedback