BRANZ TR8 Software - Concrete Floor Systems - Overview
- Valid from
- Information provider
- BRANZ Limited
- Information type
- Technical recommendation
TR8 software is a model to predict the fire resistance of concrete slabs and floor systems, and can be used for the design of reinforced or prestressed concrete floor systems when required to have fire resistance.
TR8 is based on BRANZ Technical Recommendation No. 8 - Method for Fire Engineering Design of Structural Concrete Beams and Floor Systems, which you should use to gain an understanding of the basis for the software. BRANZ Technical Recommendation No. 8 is referenced by NZS 3101 as an acceptable calculation method for determining the fire resistance of concrete floor systems. The underlying procedure applies structural engineering principles and material properties at elevated temperature to the calculation of the fire resistance of reinforced or prestressed concrete floor systems.
TR8 applies to floor systems:
- which may be rectangular or tapered in cross-section (for beams), or tee-beams, with a minimum width of 100 mm;
- which are made with normal-weight concrete (assumed density greater or equal to 2000 kg per m3), light-weight concrete (assumed to be less than 2000 kg per m3), and the following for slabs only - alluvial quartz concrete (equivalent to NZS 3101 Type A), dacite aggregate concrete (equivalent to NZS 3101 Type B) or pumice aggregate concrete (equivalent to NZS 3101 Type C);
- in which support conditions are assumed to be either simply supported or continuous over the supports;
- where the section includes either prestressing tendons or deformed reinforcing bars;
- which are designed in accordance with the requirements of NZS 3101, New Zealand Code of Practice for the Design of Concrete Structures and NZS 4203, New Zealand Standard Code of Practice for General Structural Design and Design Loadings for Buildings;
- where it is assumed that the concrete element has reached its equilibrium moisture content, and that the occurrence of concrete spalling during fire will be minimal;
- where the mode of failure for the floor system is assumed to be in flexure; failure is taken as the time at which the reduced moment capacity of the element becomes less than the moment applied to the element; and
- where factors of safety are already included into the fire resistance period and with respect to the normal design loads. In fire design it is normal to allow the load factors and design live loads to be reduced.