AS 3894.1-2002 (R2013) Site testing of protective coatings. Non-conductive coatings - Continuity testing - High voltage ('brush') method

Abbreviation
AS 3894.1-2002
Valid from
7/06/2002

Information provider
Intertek Inform
Author
Standards Australia
Information type
Australian Standard
Format
PDF, HARD COPY


Description

This Standard provides a practical test method for the on-site determination of the presence of pinholes, holidays, cracks and other discontinuities that penetrate to the substrate, in a non-conductive, protective coating of at least 150 mm thickness (see Note) on a conductive substrate, using the high voltage or ‘brush’ method.

NOTE: Where coatings are less than 150 mm thick, an alternative method such as the low voltage wet sponge method should be used.

Scope

This Standard is applicable to site testing of coated metal items of equipment or structures which may be subjected to long-term burial or immersion, such as structural steel, pipelines, storage vessels, bridges and mobile/transportable containers. The method is confined to testing instruments that can provide a minimum voltage of 500 V. The Standard is not intended to apply to coating types incorporating components that conduct an electric current, such as zinc dust and aluminium flakes.

The voltages recommended in this Standard are intended to be applied under conditions of normal atmospheric pressure and temperature.

For assistance with locating previous versions, please contact the information provider.
View on Information Provider website
For assistance with locating previous versions, please contact the information provider.
This resource is cited by:

AS 3894.1-2002 (R2013) Site testing of protective coatings. Non-conductive coatings - Continuity testing - High voltage ('brush') method

This document is CITED BY:

AS 3894.1-2002 (R2013) Site testing of protective coatings. Non-conductive coatings - Continuity testing - High voltage ('brush') method

Description

This Standard provides a practical test method for the on-site determination of the presence of pinholes, holidays, cracks and other discontinuities that penetrate to the substrate, in a non-conductive, protective coating of at least 150 mm thickness (see Note) on a conductive substrate, using the high voltage or ‘brush’ method.

NOTE: Where coatings are less than 150 mm thick, an alternative method such as the low voltage wet sponge method should be used.

View on Information Provider website
AS 3894.1-2002 (R2013) Site testing of protective coatings. Non-conductive coatings - Continuity testing - High voltage ('brush') method
Description

This Standard provides a practical test method for the on-site determination of the presence of pinholes, holidays, cracks and other discontinuities that penetrate to the substrate, in a non-conductive, protective coating of at least 150 mm thickness (see Note) on a conductive substrate, using the high voltage or ‘brush’ method.

NOTE: Where coatings are less than 150 mm thick, an alternative method such as the low voltage wet sponge method should be used.

View on Information Provider website
This resource does not cite any other resources.

AS 3894.1-2002 (R2013) Site testing of protective coatings. Non-conductive coatings - Continuity testing - High voltage ('brush') method

This resource does not CITE any other resources.
Feedback