Save

AS 2207-2007 (R2017) Non-destructive testing - Ultrasonic testing of fusion welded joints in carbon and low alloy steel

Abbreviation
AS 2207-2007
Valid from
12/07/2007

Information provider
SAI Global
Author
Standards Australia
Information type
Australian Standard
Format
PDF


Description

This Standard sets out methods and requirements for the manual ultrasonic testing of full or partial penetration fusion welded joints in carbon and low alloy ferritic steels, 6 mm or greater in thickness, using A-scan presentation and employing four sensitivity levels.


Scope

This Standard does not cover the testing of stainless steel.

It does not cover the testing of longitudinal welds when - 

  • the radius of curvature of fabrications is less than 125 mm; or
  • for tubular fabrications having an outside diameter exceeding 250 mm, the ratio of thickness to outside diameter exceeds 0.22.

NOTE: Advice and recommendations on information to be supplied by the purchaser at the time of enquiry or order are contained in the purchasing guidelines set out in Appendix A.

For assistance with locating previous versions, please contact the information provider.
View on Information Provider website
For assistance with locating previous versions, please contact the information provider.
This resource is cited by:

AS 2207-2007 (R2017) Non-destructive testing - Ultrasonic testing of fusion welded joints in carbon and low alloy steel

This document is CITED BY:

AS 2207-2007 (R2017) Non-destructive testing - Ultrasonic testing of fusion welded joints in carbon and low alloy steel

Description

This Standard sets out methods and requirements for the manual ultrasonic testing of full or partial penetration fusion welded joints in carbon and low alloy ferritic steels, 6 mm or greater in thickness, using A-scan presentation and employing four sensitivity levels.


View on Information Provider website
AS 2207-2007 (R2017) Non-destructive testing - Ultrasonic testing of fusion welded joints in carbon and low alloy steel
Description

This Standard sets out methods and requirements for the manual ultrasonic testing of full or partial penetration fusion welded joints in carbon and low alloy ferritic steels, 6 mm or greater in thickness, using A-scan presentation and employing four sensitivity levels.


View on Information Provider website
This resource does not cite any other resources.

AS 2207-2007 (R2017) Non-destructive testing - Ultrasonic testing of fusion welded joints in carbon and low alloy steel

This resource does not CITE any other resources.
Save
Feedback