AS 1984-1977 Vernier callipers (metric series)

Abbreviation
AS 1984-1977
Valid from
1/09/1977

Information provider
Intertek Inform,
Author
Standards Australia
Information type
Australian Standard,
Format
PDF, HARD COPY,


Description

This Standard specifies materials, properties, basic design details, accuracy and finish of vernier callipers reading to 0.1 and 0.05 mm in sizes up to 1000 mm and to 0.02 mm in sizes up to 300 mm. An appendix gives notes on the testing of the more important features of the instruments. It does not apply to dial callipers but these callipers may comply except for read-out and indicating mechanism.

Scope

This standard specifies requirements for vernier callipers reading to 0,1 (1/10), 0,05 (1/20), and 0,02 (1/50) mm, and having measuring ranges as given in Table 1.

Requirements for materials and properties, basic design, accuracy and finish are also specified.

Note: Notes on methods for testing the more important features of vernier callipers are given in Appendix A. These notes are for guidance only and do not purport to be either recommended or mandatory methods of test.

Although dial callipers are not specified in this standard (see Preface), they should comply with all relevant requirements except those for the read-out and indicating mechanism.

For assistance with locating previous versions, please contact the information provider.
View on Information Provider website
For assistance with locating previous versions, please contact the information provider.
This resource is cited by:

AS 1984-1977 Vernier callipers (metric series)

This document is CITED BY:

AS 1984-1977 Vernier callipers (metric series)

Description

This Standard specifies materials, properties, basic design details, accuracy and finish of vernier callipers reading to 0.1 and 0.05 mm in sizes up to 1000 mm and to 0.02 mm in sizes up to 300 mm. An appendix gives notes on the testing of the more important features of the instruments. It does not apply to dial callipers but these callipers may comply except for read-out and indicating mechanism.

View on Information Provider website
AS 1984-1977 Vernier callipers (metric series)
Description

This Standard specifies materials, properties, basic design details, accuracy and finish of vernier callipers reading to 0.1 and 0.05 mm in sizes up to 1000 mm and to 0.02 mm in sizes up to 300 mm. An appendix gives notes on the testing of the more important features of the instruments. It does not apply to dial callipers but these callipers may comply except for read-out and indicating mechanism.

View on Information Provider website
This resource does not cite any other resources.

AS 1984-1977 Vernier callipers (metric series)

This resource does not CITE any other resources.
Feedback