AS 1627.4-1989 Metal finishing - Preparation and pretreatment of surfaces - Part 4: Abrasive blast cleaning

Abbreviation
AS 1627.4-1989
Valid from
1/01/1989

Information provider
Intertek Inform,
Author
Standards Australia
Information type
Australian Standard,
Format
PDF, HARD COPY,


Description

This Standard describes the procedures and equipment required for abrasive blast cleaning of metal surfaces. Classifies degrees of surface preparation. An appendix provides methods for measuring the profile height of blasted surfaces.

Scope

This Standard specifies surface preparation and describes procedures for the abrasive blast cleaning of metal surfaces prior to application of protective coatings, with specific reference to steel. Guidance is given on the choice of abrasives, abrasive methods and types of application.

Notes:

  1. Certain abrasives and blast cleaning methods may be incompatible. State health regulations may prohibit the use of certain dust producing abrasives (see Clause 2.5).
  2. Appendix A contains advice and recommendations on information which should be supplied by the purchaser at the time of enquiry or order.
For assistance with locating previous versions, please contact the information provider.
View on Information Provider website
For assistance with locating previous versions, please contact the information provider.
This resource is cited by:

AS 1627.4-1989 Metal finishing - Preparation and pretreatment of surfaces - Part 4: Abrasive blast cleaning

This document is CITED BY:

AS 1627.4-1989 Metal finishing - Preparation and pretreatment of surfaces - Part 4: Abrasive blast cleaning

Description

This Standard describes the procedures and equipment required for abrasive blast cleaning of metal surfaces. Classifies degrees of surface preparation. An appendix provides methods for measuring the profile height of blasted surfaces.

View on Information Provider website
AS 1627.4-1989 Metal finishing - Preparation and pretreatment of surfaces - Part 4: Abrasive blast cleaning
Description

This Standard describes the procedures and equipment required for abrasive blast cleaning of metal surfaces. Classifies degrees of surface preparation. An appendix provides methods for measuring the profile height of blasted surfaces.

View on Information Provider website
This resource does not cite any other resources.

AS 1627.4-1989 Metal finishing - Preparation and pretreatment of surfaces - Part 4: Abrasive blast cleaning

This resource does not CITE any other resources.
Feedback