Save

AS 1101.3-2005 (R2018) Graphical symbols for general engineering - Part 3: Welding and non-destructive examination

Abbreviation
AS 1101.3-2005
Valid from
31/03/2005

Information provider
SAI Global
Author
Standards Australia
Information type
Australian Standard
Format
PDF


Description

This Standard specifies symbols that provide the means of placing complete welding information on drawings.

It describes the application of these symbols and includes illustrated examples for their use in various welding processes.

A separate section covers the symbols to be used on drawings to specify non-destructive examination requirements. 

Scope

This Standard describes symbols that provide the means of placing complete welding information on drawings. It covers the details of symbols and requirements for their application in various welding processes (including brazing), and non-destructive examination.

Appendix A gives a listing of abbreviations normally used for welding and allied processes.

For assistance with locating previous versions, please contact the information provider.
View on Information Provider website
For assistance with locating previous versions, please contact the information provider.
This resource is cited by:

AS 1101.3-2005 (R2018) Graphical symbols for general engineering - Part 3: Welding and non-destructive examination

This document is CITED BY:

AS 1101.3-2005 (R2018) Graphical symbols for general engineering - Part 3: Welding and non-destructive examination

Description

This Standard specifies symbols that provide the means of placing complete welding information on drawings.

It describes the application of these symbols and includes illustrated examples for their use in various welding processes.

A separate section covers the symbols to be used on drawings to specify non-destructive examination requirements. 

View on Information Provider website
AS 1101.3-2005 (R2018) Graphical symbols for general engineering - Part 3: Welding and non-destructive examination
Description

This Standard specifies symbols that provide the means of placing complete welding information on drawings.

It describes the application of these symbols and includes illustrated examples for their use in various welding processes.

A separate section covers the symbols to be used on drawings to specify non-destructive examination requirements. 

View on Information Provider website
This resource does not cite any other resources.

AS 1101.3-2005 (R2018) Graphical symbols for general engineering - Part 3: Welding and non-destructive examination

This resource does not CITE any other resources.
Save
Feedback