The Metalcraft Insulated Panel System comprises:

• Fully finished internal/external wall and roofing panels, and
• The following ancillary components:
• 40x40x1.6mm aluminium angles
• 12mm hold-down bolt
• 10mm mushroom bolts
• Flashings
• 4.8x14.3mm (ASMG63.66) aluminium rivets
• 70x50x5mm plate washers 
• 14 gauge self-drilling screws with 25mm steel washer
• Silicone sealant

The Metalcraft Insulated Panels are branded as:

• ThermoPanel, and
• ThermoSpan

They are manufactured from a Class S (AS1366.3-1992) expanded EPS core with factory laminated COLORSTEEL® facings of 0.4 to 0.6mm thickness.

The MetalCraft Insulated Panels are available in the following thicknesses (mm): 50, 75, 100, 150, 200, 250 and 300.

The Metalcraft Insulated Panel System is certified for use as:

• a fully finished internal/external wall or roof cladding system or

• a structural wall system providing bracing capacity for wind and seismic loads

For new or existing buildings within the following scope:

• A risk score of 0-20, calculated using Table 1 & Table 2, Acceptable Solution E2/AS1, Third Edition including amendment

  8 (30/11/2018), and

• Situated in all corrosion zones as defined in NZS3604:2011 except microclimate and less than 50m from breaking surf; and

• Located further than 1m from the relevant boundary; and

• With either:

  1. A Building height of up to 10m in wind zones up to and including extra high as defined in NZS3604:2011, or

  2. A building height determined by specific design limited by a maximum design differential wind pressure (ULS) of

     2.5kPa

• Roof pitch minimum of 3 degrees; and

• With timber or steel framing when used as a cladding.