AS 5100.5-2004 Bridge design - Concrete

Abbreviation
AS 5100.5-2004
Amendment
AS 5100.5-2004/Amdt 1-2010 AS 5100.5-2004/Amdt 2-2010
Valid from
23/04/2004

Information provider
SAI Global
Author
Standards Australia
Information type
Australian Standard
Format
PDF

Description

This Standard sets out minimum requirements for the design and construction of concrete bridges and associated structures, including members that contain reinforcing steel or tendons, or both, in limit states format.

Scope

This Standard applies to concrete structures made using the following materials:

  • (a) Concrete with a characteristic compressive strength at 28 days (f c)   in the range of 25 MPa to 65 MPa and with a saturated surface-dry density in the range of 2100 kg/m3 to 2800 kg/m3 .
  • (b) Reinforcing steels complying with AS/NZS 4671, and the following criteria:
    • (i) Yield strength (fsy) of 500 MPa and Ductility Class N. These reinforcing materials may be used, without restriction, in all applications referred to in this Standard.
    • (ii) Yield strength (fsy) of 500 MPa and Ductility Class L. These reinforcing materials shall not be used in any situation where the reinforcement is expected to undergo large deformation under strength limit state conditions or any situation where the bar is likely to be bent or rebent on site (see Note 1).
    • (iii) Round bars of yield strength (fsy) of 250 MPa and Ductility Class N. These reinforcing bars shall only be used for fitments.
  • (c) Prestressing tendons complying with AS 1310, AS 1311 or AS 1313, as appropriate (see Note 2).

Notes:

  1. The use of Ductility Class L reinforcement is further limited by other clauses within this Standard.
  2. The design of a structure or member to which this Standard applies should be the responsibility of an engineer as defined in AS 5100.1.
For assistance with locating previous versions, please contact the information provider.
View on Information Provider website
For assistance with locating previous versions, please contact the information provider.
This resource is not cited by any other resources.

AS 5100.5-2004 Bridge design - Concrete

This document is not CITED BY any other resources:

AS 5100.5-2004 Bridge design - Concrete

Description

This Standard sets out minimum requirements for the design and construction of concrete bridges and associated structures, including members that contain reinforcing steel or tendons, or both, in limit states format.

View on Information Provider website
AS 5100.5-2004 Bridge design - Concrete
Description

This Standard sets out minimum requirements for the design and construction of concrete bridges and associated structures, including members that contain reinforcing steel or tendons, or both, in limit states format.

View on Information Provider website
This resource does not cite any other resources.

AS 5100.5-2004 Bridge design - Concrete

This resource does not CITE any other resources.
Feedback