AS 1627.4-2005 (R2017) Metal finishing - Preparation and pretreatment of surfaces - Abrasive blast cleaning of steel

Abbreviation
AS 1627.4-2005
Valid from
23/12/2005

Information provider
Intertek Inform,
Author
Standards Australia
Information type
Australian Standard,
Format
PDF, HARD COPY,


Description

This standard specifies abrasive blast cleaning methods for the preparation of steel surfaces before coating with paints and related products. 

Scope

This Standard also contains information on the effectiveness of the individual methods and their fields of application.

This standard is applicable to new and corroded steel surfaces and also to steel surfaces that are uncoated or have been previously coated with paints and related products.

These methods are essentially intended for the surface preparation of hot-rolled steel but could also be used for cold-rolled steel of sufficient thickness to withstand the deformation caused by the impact of abrasive. Items considered as a part of surface preparation before coating are edge grinding, removal of grease and oil, removal of weld spatter, removal of burrs and other sharp edges, grinding of welds, filling of pits, porosity of welds and other surface imperfections and removal of water-soluble contaminants that may cause premature failure of the coating system. Such defects cannot be satisfactorily treated by abrasive blast cleaning.

For assistance with locating previous versions, please contact the information provider.
View on Information Provider website
For assistance with locating previous versions, please contact the information provider.
This resource is cited by:

AS 1627.4-2005 (R2017) Metal finishing - Preparation and pretreatment of surfaces - Abrasive blast cleaning of steel

This document is CITED BY:

AS 1627.4-2005 (R2017) Metal finishing - Preparation and pretreatment of surfaces - Abrasive blast cleaning of steel

Description

This standard specifies abrasive blast cleaning methods for the preparation of steel surfaces before coating with paints and related products. 

View on Information Provider website
AS 1627.4-2005 (R2017) Metal finishing - Preparation and pretreatment of surfaces - Abrasive blast cleaning of steel
Description

This standard specifies abrasive blast cleaning methods for the preparation of steel surfaces before coating with paints and related products. 

View on Information Provider website
This resource does not cite any other resources.

AS 1627.4-2005 (R2017) Metal finishing - Preparation and pretreatment of surfaces - Abrasive blast cleaning of steel

This resource does not CITE any other resources.
Feedback